what are you gaining by doing this ? I haven't found anything that supports it.
-----Original Message----- From: IBM Mainframe Discussion List [mailto:[EMAIL PROTECTED] Behalf Of Craig Kittendorf Sent: Monday, July 25, 2005 1:40 PM To: IBM-MAIN@BAMA.UA.EDU Subject: Re: ILR005E PLPA PAGE DATA SET FULL Is that recommendation in an IBM manual so that it satisfies management? Thanks -----Original Message----- From: IBM Mainframe Discussion List [mailto:[EMAIL PROTECTED] On Behalf Of Ted MacNEIL Sent: Sunday, July 24, 2005 8:00 PM To: IBM-MAIN@BAMA.UA.EDU Subject: Re: ILR005E PLPA PAGE DATA SET FULL ... This is not usually my responsibility. However, what is the procedure for re-allocating the plpa page dataset? ILR005E PLPA PAGE DATA SET FULL, OVERFLOWING TO COMMON DATA SET ... In this case, DON'T! This has been the way to go (recommended by IBM), since before MVS/XA. Allocate a 1-cylinder PLPA, on the same pack as the CSA page dataset. Ingnore the message. Go on with life. (8-{]} -teD ---------------------------------------------------------------------- For IBM-MAIN subscribe / signoff / archive access instructions, send email to [EMAIL PROTECTED] with the message: GET IBM-MAIN INFO Search the archives at http://bama.ua.edu/archives/ibm-main.html ---------------------------------------------------------------------- For IBM-MAIN subscribe / signoff / archive access instructions, send email to [EMAIL PROTECTED] with the message: GET IBM-MAIN INFO Search the archives at http://bama.ua.edu/archives/ibm-main.html