Hello,
Iff you have OSA-E 1000BaseT look for in redbook site for OSA-ICC. It
describes step by step how to configure it.
Carlos Bodra
IBM zSeries Certified Specialist
Sao Paulo - Brazil
Em 30/11/2010 15:42, SrinivasG escreveu:
Hi,
On the Z800 , we had a separate 2074 controller for SNA Connectivity. In the
Z10BC , I understand , its integrated into the HMC. How do I configure the same
for an LPAR? Is there documentation that describes it? I have looked everywhere
but could not find it. Any pointers?
Regards,
Srinivas G
**************** CAUTION - Disclaimer *****************
This e-mail contains PRIVILEGED AND CONFIDENTIAL INFORMATION intended solely
for the use of the addressee(s). If you are not the intended recipient, please
notify the sender by e-mail and delete the original message. Further, you are
not
to copy, disclose, or distribute this e-mail or its contents to any other
person and
any such actions are unlawful. This e-mail may contain viruses. Infosys has
taken
every reasonable precaution to minimize this risk, but is not liable for any
damage
you may sustain as a result of any virus in this e-mail. You should carry out
your
own virus checks before opening the e-mail or attachment. Infosys reserves the
right to monitor and review the content of all messages sent to or from this
e-mail
address. Messages sent to or from this e-mail address may be stored on the
Infosys e-mail system.
***INFOSYS******** End of Disclaimer ********INFOSYS***
----------------------------------------------------------------------
For IBM-MAIN subscribe / signoff / archive access instructions,
send email to lists...@bama.ua.edu with the message: GET IBM-MAIN INFO
Search the archives at http://bama.ua.edu/archives/ibm-main.html
----------------------------------------------------------------------
For IBM-MAIN subscribe / signoff / archive access instructions,
send email to lists...@bama.ua.edu with the message: GET IBM-MAIN INFO
Search the archives at http://bama.ua.edu/archives/ibm-main.html