Hi, My question is going to be very general. Our shop has the policy of running daily back up from Mon-friday on a incremental basis(Volume Level). So we have been using this Keyword at sysin control card : DATASET(INCLUDE(**) BY(DSCHA,EQ,YES), which means that the backup would take place only if any changes have been occurred on a specific Volume. Recently in our Z/OS 1.13 Testing box we ended with Below error.
ADR049E (001)-STEND(01), 2012.340 15:29:13 DFSMSDSS FUNCTION TASK ABEND RECOVERY ROUTINE WAS ENTERED. SYSTEM ABEND CODE=0A13 REASON CODE=0010 and also followed by the below error : IEC151I A13-10,IFG0195H,TS1IN4$,STEP01,TAPE1,0890,TS1IN4,BACKUP.INC.MTWK05 IEC151I Explanation: The error occurred during processing of an OPEN macro instruction for a data set on magnetic tape. In the message text: rc Associates this message with system completion code A13 and with the return code. jjj The job name. sss The step name. ddname[-#] DDname (followed by a concatenation number if it is part of a concatenation and not the first DD statement in the concatenation). dev The device number. ser The volume serial number. mod The name of the module in which the error occurred. dsname The data set name. The explanation for the hex return code is as follows: Return Code Explanation: 10 A tape mark was read instead of a HDR1 label while forward spacing to the desired file on an SL or AL tape. Thus, the multifile tape ends before the desired file. When positioning to the end of file 1, this means the vol label is followed by a tape mark. Probable user error. Check the file sequence number and volume serial numbers and that the job that wrote the tape wrote all the files I believe that when there is no dataset on a particular Label then it will not proceed with the other LABEL and would end up with above error message. We have never had this issue in past even if a particular LABEL does not have a dataset and it obviously moves on to next label for backup. I hope as per the design it should work and I am totally confused by the above reply. The JCL which we are using like below : //STEP01 EXEC PGM=ADRDSSU PARM='TYPRUN=NORUN' //SYSPRINT DD SYSOUT=* //DASD1 DD UNIT=3390,VOL=SER=&VOL,DISP=SHR //TAPE1 DD UNIT=890,VOL=(,RETAIN,SER=&TAPE),DISP=(NEW,KEEP), // DSNAME=BACKUP.INC.&VOL,LABEL=(&LBL,SL) //SYSIN DD DSN=JAKE.TEST.CNTL(CARD),DISP=SHR //BACKUP PEND //DASD01 EXEC BACKUP,VOL=TVX3A1,TAPE=TS1IN4,LBL=01 //DASD02 EXEC BACKUP,VOL=TVX3A2,TAPE=TS1IN4,LBL=02 //DASD03 EXEC BACKUP,VOL=MTWK05,TAPE=TS1IN4,LBL=03 Any suggestion are highly appreciated. Jake ---------------------------------------------------------------------- For IBM-MAIN subscribe / signoff / archive access instructions, send email to lists...@listserv.ua.edu with the message: INFO IBM-MAIN
