Issuing an "I" in SDSF NP column gets Invalid command
Thanks, Tim -----Original Message----- From: IBM Mainframe Discussion List [mailto:IBM-MAIN@LISTSERV.UA.EDU] On Behalf Of Lizette Koehler Sent: Monday, 07 January, 2013 10:06 AM To: IBM-MAIN@LISTSERV.UA.EDU Subject: Re: Jes2 - $DO JOBQ,READY When you say stop working, I assume you mean it is not selecting work. Find a job you think should be actioned by the command, then go into SDSF and issue an I against that job. See if it matches the criteria for your command. Sometimes JES2 will not select work because it does not match the work selection criteria. I find the I (INFO) command in SDSF sometimes helpful. You may not have work that is READY. It may be held ins some fashion. Lizette > -----Original Message----- > From: IBM Mainframe Discussion List [mailto:IBM-MAIN@LISTSERV.UA.EDU] > On Behalf > Of Tim Brown > Sent: Monday, January 07, 2013 7:52 AM > To: IBM-MAIN@LISTSERV.UA.EDU > Subject: Jes2 - $DO JOBQ,READY > > This command recently stopped working eventhough there is output in > the JES2 output > that it should display output for. I have an identical Z/OS system > where it does display > the output properly. > > Thanks, > > Tim Brown N ---------------------------------------------------------------------- For IBM-MAIN subscribe / signoff / archive access instructions, send email to lists...@listserv.ua.edu with the message: INFO IBM-MAIN ---------------------------------------------------------------------- For IBM-MAIN subscribe / signoff / archive access instructions, send email to lists...@listserv.ua.edu with the message: INFO IBM-MAIN
