The only dumb question is the one you should have asked but didn't. As long as you include supporting details with the question and ask in the correct forum, there's no need to be embarrassed if the answer turns out to be obvious. BTDT,GTTS.
-- Shmuel (Seymour J.) Metz http://mason.gmu.edu/~smetz3 עַם יִשְׂרָאֵל חַי נֵ֣צַח יִשְׂרָאֵ֔ל לֹ֥א יְשַׁקֵּ֖ר ________________________________________ From: IBM Mainframe Discussion List <[email protected]> on behalf of Peter <[email protected]> Sent: Sunday, September 14, 2025 12:37 AM To: [email protected] <[email protected]> Subject: Adding new UCB to IODF External Message: Use Caution Hello Apologies for the dummy question and I must confess that I have inherited this task recently. I have added a new range of UCB 7000,128 and 7080,128 We have lpar TSOA and TSOB both are monoplex on same CEC. Usually the TSOA is used for building the IODF and after that the exported copy is transferred to TSOB. I have added new series of LCU and LUN in DS8K box. From the ZOS I have also added the same device pointing to the CU used in DS8K box So here is the message I get while doing test only activation and just wanted to know if these messages are OK ? ----------Device------ --#--- --------Control Unit Numbers + -------- / Number Type + CSS OS 1--- 2--- 3--- 4--- 5--- 6--- 7--- 8--- _ 7000,128 3390B 1 5 7000 ____ ____ ____ ____ ____ ____ ____ _ 7080,128 3390A 1 2 7000 ____ ____ ____ ____ ____ ____ ____ ******************************* Bottom of data ******************************** / Sev Msg. ID Message Text _ W CBDA333I EDT 01 of OS configuration ZOSEPROD does not use tokens # for its esoterics. _ W CBDA333I EDT 01 of OS configuration ZOSETEST does not use tokens # for its esoterics. _ W CBDG061I Switch control unit must be defined for switch 69. _ W CBDG061I Switch control unit must be defined for switch 6A. _ W CBDG061I Switch control unit must be defined for switch 75. _ W CBDG061I Switch control unit must be defined for switch 76. / Sev Msg. ID Message Text _ I IOS500I ACTIVATE RESULTS # TEST DETECTED NO CONDITIONS WHICH WOULD RESULT IN # ACTIVATE FAILURE _ I NOTE = 0100,SOFTWARE-ONLY CHANGE # COMPID=SC1C3 _ I NOTE = 010B,H/W AND S/W CONFIGURATION DEFINITIONS WILL # BE OUT OF SYNC # COMPID=SC1C3 _ I CBDA126I ACTIVATE IODF=12,SOFT=NOVALIDATE,TEST command was # accepted. _ I CBDA854I Changes to Coupling Facility and function elements are processed. Any guidance and pointers are much appreciated. Regards Peter ---------------------------------------------------------------------- For IBM-MAIN subscribe / signoff / archive access instructions, send email to [email protected] with the message: INFO IBM-MAIN ---------------------------------------------------------------------- For IBM-MAIN subscribe / signoff / archive access instructions, send email to [email protected] with the message: INFO IBM-MAIN
