Booooo That's what I was afraid of. :( Anne D. Crabtree System Programmer WV Office of Technology Data Center 1900 Kanawha Blvd East Bldg 6, Room B-110 Charleston, WV 25305 (304)957-8292 (304)558-1441 fax
-----Original Message----- From: IBM Mainframe Discussion List [mailto:IBM-MAIN@LISTSERV.UA.EDU] On Behalf Of Staller, Allan Sent: Tuesday, July 21, 2015 1:36 PM To: IBM-MAIN@LISTSERV.UA.EDU Subject: Re: JES2 SPOOL question It is my understanding that this is the purpose of $MSPL, but I did not have much luck (probably due to a procedural error(?) on my part). I just went through the process in reverse. Migrating Mod 3 spool to Mod 9. I issued a $PSPL prior to the $MSPL. When the $MSPL was issued, very little actually happened. It has been my experience that there is always "something" on the spool volume being drained that will require an IPL to make the "something" available for deletion. Given a SYSPLEX, this is a non-issue. Once the "something" is available for deletion, SPOOL offload/reload, or just plain $P* can be used to free the original spool volume. HTH, <snip> In JES2, I have 11 SPOOL volumes but the last two I added were mod 9's, whereas, the others are mod 3's. I did not mean to put the SPOOL volumes on mod 9's. I have issued the drain ($PSPOOLA) to drain that volume but there is obviously a lot of stuff on it and I don't know how long it will take to drain! After it drains, I will run jobs to INIT, FORMAT, and START the new SPOOLA (which will be a mod 3). My question is: Can I use the $MSPL to migrate the contents of SPOOLA to a differently named SPOOL volume(say, SPOOLC)? I'm assuming , in that case, I would only need to INIT a mod 3 with a different name. I'm thinking that might be a better way to get rid of the mod 9 and implement the mod 3 more quickly. Some of the "stuff" on SPOOLA is EXECUTING rather than, for example, AWAITING HARDCOPY. There is also the issue of the differing size of the packs (mod 9 vs mod 3). </snip> ---------------------------------------------------------------------- For IBM-MAIN subscribe / signoff / archive access instructions, send email to lists...@listserv.ua.edu with the message: INFO IBM-MAIN ---------------------------------------------------------------------- For IBM-MAIN subscribe / signoff / archive access instructions, send email to lists...@listserv.ua.edu with the message: INFO IBM-MAIN
