Why not CP SIGNAL SHUTDOWN ALL instead of the table.
Regards, Richard Schuh ________________________________ From: The IBM z/VM Operating System [mailto:ib...@listserv.uark.edu] On Behalf Of Mark Pace Sent: Wednesday, June 03, 2009 10:55 AM To: IBMVM@LISTSERV.UARK.EDU Subject: Re: Clean Linux Guest Shutdown I have an exec I run that runs through a table and sends the command to each linux. 'CP SIGNAL SHUTDOWN ' linux ' WITHIN 60' On Wed, Jun 3, 2009 at 1:49 PM, Adam Thornton <athorn...@sinenomine.net<mailto:athorn...@sinenomine.net>> wrote: On Jun 3, 2009, at 12:43 PM, Robert J McCarthy wrote: I am trying to develop a shutdown procedure to cleanly shutdown my linux guests, prior to shutting down vm. Reading the documentation in the virtualization cookbook for SLES10 and the vm CP COMMANDS manual; I have setup the following : 1. In each linux guest's /etc/inittab; I have changed the shutdown -r to shutdown -h 2. In my autolog1 exec I have placed the following command: CP SET SIGNAL SHUTDOWN 1200 ( To allow the guests 20 minutes to respond) Note: I have also entered the command manually When I issue the shutdown, vm shuts down before most if not all linux guests have responded or completed shutdown; always within a minute or two. As a result I end up with file corruption in some linux guests after vm is re-IPLed and the guests are brought back up. Is there a better way to accomplish a clean linux shutdown. Thank you, Bob Our SYSVINIT drop-in-replacement for a list-of-machines-in-autolog would do the trick. It may be overkill. Adam -- Mark Pace Mainline Information Systems 1700 Summit Lake Drive Tallahassee, FL. 32317
