Anthony, The problem with allocating numbers sequentially is the impact on routers and routing protocols. I have heard that the Japanese issue house numbers chronologically. When you find the right block, you have to hunt for the right number. What you are suggesting is similar. You would have as many routing table entries as hosts in the world. The router would not be affordable. The traffic for routing entries would swamp the net. The processing of these routing advertisements would be impossible. It doesn't scale! The function of an address is to enable a router to find it. That is why we try to use hierarchical addressing even at the cost of numbering space.
IMO one problem of the Internet is that it isn't hierarchical enough. Consider the phone system: country codes, area codes ... This makes the job of building a switch much easier. I think we should have divided the world into 250 countries. Each country into 250 "provinces". Yes, it would waste address space but it would make routing much easier and more deterministic. It would simplify BGP drastically. Current routing algorithms aren't that efffective. Paths in the net are fairly inefficient. This increases latency, apparent traffic on the net, and is a real waste of money. Yes this would mean a mobile node needs to get new addresses as it moves. So what. We already have DHCP. Cell phones do a handoff already. Steve Silverman > -----Original Message----- > From: Anthony G. Atkielski [mailto:[EMAIL PROTECTED] > Sent: Wednesday, March 29, 2006 11:27 PM > To: ietf@ietf.org > Subject: Re: 128 bits should be enough for everyone,was: > IPv6 vs. Stupid > NAT tricks: false dichotomy? (Was: Re: StupidNAT tricks and > how to stop > them.) > > > Iljitsch van Beijnum writes: > > > So how big would you like addresses to be, then? > > It's not how big they are, it's how they are allocated. > And they are > allocated very poorly, even recklessly, which is why they run out so > quickly. It's true that engineers always underestimate required > capacity, but 128-bit addresses would be enough for anything ... IF > they were fully allocated. But I know they won't be, and so the > address space will be exhausted soon enough. > > > We currently have 1/8th of the IPv6 address space set aside for > > global unicast purposes ... > > Do you know how many addresses that is? One eighth of 128 bits is a > 125-bit address space, or > > 42,535,295,865,117,307,932,921,825,928,971,026,432 > > addresses. That's enough to assign 735 IP addresses to every cubic > centimetre in the currently observable universe (yes, I calculated > it). Am I the only person who sees the absurdity of wasting > addresses > this way? > > It doesn't matter how many bits you put in an address, if you assign > them this carelessly. > > > ... with the idea that ISPs give their customers /48 blocks. > > Thank you for illustrating the classic engineer's mistake. Stop > thinking in terms of _bits_, and think in terms of the > _actual number > of addresses_ available. Of better still, start thinking > in terms of > the _number of addresses you throw away_ each time you set aside > entire bit spans in the address for any predetermined purpose. > > Remember, trying to encode information in the address (which is what > you are doing when you reserve bit spans) results in > exponential (read > incomprehensibly huge) reductions in the number of available > addresses. It's trivially easy to exhaust the entire address space > this way. > > If you want exponential capacity from an address space, you have to > assign the addresses consecutively and serially out of that address > space. You cannot encode information in the address. You cannot > divided the address in a linear way based on the bits it > contains and > still claim to have the benefits of the exponential number of > addresses for which it supposedly provides. > > Why is this so difficult for people to understand? > > > That gives us 45 bits worth of address space to use up. > > You're doing it again. It's not 45 bits; it's a factor of > 35,184,372,088,832. > > But rest assured, they'll be gone in the blink of an eye if the > address space continues to be mismanaged in this way. > > > It's generally accepted that an HD ratio of 80% should be > reachable > > without trouble, which means we get to waste 20% of those > bits in > > aggregation hierarchies. > > No. It's not 20% of the bits, it's 99.9756% of your address > space that > you are wasting. > > Do engineers really study math? > > > This gives us 36 bits = 68 billion /48s. That's several per person > > inhabiting the earth, and each of those / 48s provides > 65536 subnets > > that have room to address every MAC address ever assigned without > > breaking a sweat. > > What happens when MAC addresses go away? How are you providing for > the future when you allocate address space based on the > past? Why not > just leave the address space alone, and allocate only the minimum > slice required to handle current requirements? > > That's another problem of engineers: they think they can predict the > future, and they are almost always wrong. > > > What was the problem again? > > And that's the third problem. > > Remember also: any encoding of information into the address field > (including anything that facilitates routing) exponentially reduces > the total number of available addresses. So it might look > like 2^128 > addresses, but in reality it may be 2^40, or some other very small > number, depending on how much information you try to encode into the > address. > > > > _______________________________________________ > Ietf mailing list > Ietf@ietf.org > https://www1.ietf.org/mailman/listinfo/ietf > _______________________________________________ Ietf mailing list Ietf@ietf.org https://www1.ietf.org/mailman/listinfo/ietf