I'd like to do that when I clean it up a bit. One thing I'd like to do is have it auto-recognize when its settings have changed and then reload them. I tried catching the signal "setup changed" but it doesn't send any parameters. I guess I could take over the "set" command but the changes wouldn't be in place until after my handler was called (right?).
The other thing to do would be re-initialize each time any setting is changed, but that doesn't seem right either. Mike On Thu, Mar 25, 2004 at 08:21:28PM +0100, Geert Hauwaerts wrote: > On Thu, 2004-03-25 at 20:18, Mike Weisenborn wrote: > > > > > Is there interest in this, and if so, how should I proceed in submitting > > > > this? > > You might want to submit it to [EMAIL PROTECTED] > > Regards, > Geert Hauwaerts. > > -- > .---------------------------------------------------------------------------. > | Geert Hauwaerts http://www.safeweb.be <[EMAIL PROTECTED]> | > | Certified Unix/Linux Administrator || Cisco Certified Network Associate | > `---------------------------------------------------------------------------' > > -- Mike Weisenborn, Senior Partner [EMAIL PROTECTED] 770-886-0443 www.clearbuilt.com Clearbuilt Technologies - consulting, development and education for the real estate and construction industries
