My parents are reporting that card #1, a pvr250 of 3 total, whenever it is programmed to record channel 13, there is no audio. If any of the other cards (all 250's) record 13 the audio is fine. If card 1 records any other channel its also fine.
I've copied a few seconds of an example file up and played it with mplayer, no audio there either. mplayer doesn't show anything unusual in its console output for audio either. I've checked the backend.log and syslogs and don't see anything of note. Below I've included the last syslog init of this card. Backend details: ivtv driver 0.10.1 linux 2.6.19.7 AMD XP 2500, Mandriva 2007 PP i586 3 pvr250 cards 2 HD3000 cards I don't know if I'm looking at a bad card, and bad channel database entry, driver / firmware mismatch, or something else. I posted this note to the mythtv-users group but didn't get any reply. Any thoughts? Any tests I can run to narrow down the problem? Thanks, Brian May 9 21:53:04 pvr kernel: ivtv: ==================== START INIT IVTV ==================== May 9 21:53:04 pvr kernel: ivtv: version 0.10.1 (tagged release) loading May 9 21:53:04 pvr kernel: ivtv: Linux version: 2.6.19.7_bkf2 mod_unload K7 May 9 21:53:04 pvr kernel: ivtv: In case of problems please include the debug info between May 9 21:53:04 pvr kernel: ivtv: the START INIT IVTV and END INIT IVTV lines, along with May 9 21:53:04 pvr kernel: ivtv: any module options, when mailing the ivtv-users mailinglist. May 9 21:53:04 pvr kernel: ivtv0: Autodetected Hauppauge card (cx23416 based) May 9 21:53:04 pvr kernel: ACPI: PCI Interrupt Link [LNK4] enabled at IRQ 9 May 9 21:53:04 pvr kernel: ACPI: PCI Interrupt 0000:01:07.0[A] -> Link [LNK4] -> GSI 9 (level, low) -> IRQ 9 May 9 21:53:04 pvr kernel: ivtv0: Unreasonably low latency timer, setting to 64 (was 32) May 9 21:53:04 pvr kernel: ieee1394: Host added: ID:BUS[0-00:1023] GUID[00e01800005ec313] May 9 21:53:04 pvr kernel: ivtv0: loaded v4l-cx2341x-enc.fw firmware (376836 bytes) May 9 21:53:04 pvr kernel: ivtv0: Encoder revision: 0x02060039 May 9 21:53:04 pvr kernel: tveeprom 2-0050: Hauppauge model 32032, rev B310, serial# 7046004 May 9 21:53:04 pvr kernel: tveeprom 2-0050: tuner model is Philips FI1236 MK2 (idx 10, type 2) May 9 21:53:04 pvr kernel: tveeprom 2-0050: TV standards NTSC(M) (eeprom 0x08) May 9 21:53:04 pvr kernel: tveeprom 2-0050: audio processor is MSP4448 (idx 27) May 9 21:53:04 pvr kernel: tveeprom 2-0050: decoder processor is SAA7115 (idx 19) May 9 21:53:04 pvr kernel: tveeprom 2-0050: has no radio, has IR remote May 9 21:53:04 pvr kernel: ivtv0: Autodetected Hauppauge WinTV PVR-250 May 9 21:53:04 pvr kernel: tuner 2-0061: chip found @ 0xc2 (ivtv i2c driver #0) May 9 21:53:04 pvr kernel: saa7115 2-0021: saa7115 found (1f7115d0e100000) @ 0x42 (ivtv i2c driver #0) May 9 21:53:04 pvr kernel: msp3400 2-0040: MSP4448G-A2 found @ 0x80 (ivtv i2c driver #0) May 9 21:53:04 pvr kernel: msp3400 2-0040: MSP4448G-A2 supports radio, mode is autodetect and autoselect May 9 21:53:04 pvr kernel: ivtv0: Registered device video0 for encoder MPEG (4 MB) May 9 21:53:04 pvr kernel: ivtv0: Registered device video32 for encoder YUV (2 MB) May 9 21:53:04 pvr kernel: ivtv0: Registered device vbi0 for encoder VBI (1 MB) May 9 21:53:04 pvr kernel: ivtv0: Registered device video24 for encoder PCM audio (1 MB) May 9 21:53:04 pvr kernel: tuner 2-0061: type set to 2 (Philips NTSC (FI1236,FM1236 and compatibles)) May 9 21:53:04 pvr kernel: ivtv0: Initialized Hauppauge WinTV PVR-250, card #0 May 9 21:53:04 pvr kernel: ivtv: ====================== NEXT CARD ====================== _______________________________________________ ivtv-devel mailing list [email protected] http://ivtvdriver.org/mailman/listinfo/ivtv-devel
