On 6/29/05, Sigurd Nes <[EMAIL PROTECTED]> wrote: > I lost the audio on the both 500-tuners when moving to ivtv-0.3.6v. > ivtv-0.3.6n,ivtv-0.3.6p and ivtv-0.3.6u works fine. > > 1 x pvr350 > 1 x pvr500mce > PAL > Kernel 2.6.12 > > Regards > > Sigurd > > > Ant Daniel wrote: > > I've just managed to get the 0.3.6 series installed on my FC3. > > > > However there is no audio coming out from my PVR-350, I tried first > > with 0.3.6n (which I had been trying to install previous;y) and then > > again with 0.3.6v. > > > > This currently makes this worthless for me and I've had to revert back > > to 0.2.0 rc3j > > > > I don't know if there's any audio coming from the sound card as is > > isn't hooked up (although I will have to do this to get the xv stuff > > working) > > > > Ant. > > > > Jun 29 15:07:01 olympus kernel: ivtv: ==================== START INIT > > IVTV ==================== > > Jun 29 15:07:02 olympus kernel: ivtv: version 0.3.6 (v) loading > > Jun 29 15:07:02 olympus kernel: ivtv: Linux version: 2.6.11-1.27_FC3 > > 686 REGPARM 4KSTACKS gcc-3.4 > > Jun 29 15:07:02 olympus kernel: ivtv: In case of problems please > > include the debug info > > Jun 29 15:07:02 olympus kernel: ivtv: between the START INIT IVTV and > > END INIT IVTV lines when > > Jun 29 15:07:02 olympus xinetd[3937]: xinetd Version 2.3.13 started > > with libwrap loadavg options compiled in. > > Jun 29 15:07:02 olympus kernel: ivtv: mailing the ivtv-devel mailinglist. > > Jun 29 15:07:02 olympus xinetd[3937]: Started working: 0 available services > > Jun 29 15:07:02 olympus kernel: ivtv: Autodetected WinTV PVR 350 card > > Jun 29 15:07:02 olympus kernel: ivtv: Found an iTVC15 based chip > > Jun 29 15:07:02 olympus kernel: ACPI: PCI Interrupt Link [LNK3] > > enabled at IRQ 12 > > Jun 29 15:07:02 olympus kernel: PCI: setting IRQ 12 as level-triggered > > Jun 29 15:07:02 olympus kernel: ACPI: PCI interrupt 0000:01:06.0[A] -> > > GSI 12 (level, low) -> IRQ 12 > > Jun 29 15:07:02 olympus kernel: ivtv: Unreasonably low latency timer, > > setting to 64 (was 32) > > Jun 29 15:07:02 olympus kernel: ivtv: XXX PCI device: 0x01e0 vendor: 0x10de > > Jun 29 15:07:02 olympus kernel: ivtv: Failed to load module tveeprom > > Jun 29 15:07:02 olympus kernel: ivtv: i2c client addr: 0x50 not found > > for command 0x0! > > Jun 29 15:07:02 olympus kernel: ivtv: Error -19 reading Hauppauge eeprom. > > Jun 29 15:07:02 olympus kernel: ivtv: Possible causes: the tveeprom > > module was not loaded, or > > Jun 29 15:07:02 olympus kernel: ivtv: the eeprom kernel module was > > loaded before the tveeprom module. > > Jun 29 15:07:02 olympus kernel: tuner: Ignoring new-style parameters > > in presence of obsolete ones > > Jun 29 15:07:02 olympus kernel: tuner: chip found at addr 0xc2 i2c-bus > > ivtv i2c driver #0 > > Jun 29 15:07:02 olympus kernel: ivtv: i2c attach [client=(tuner unset),ok] > > Jun 29 15:07:02 olympus kernel: saa7115: starting probe for adapter > > ivtv i2c driver #0 (0x10005) > > Jun 29 15:07:02 olympus kernel: saa7115: detecting saa7115 client on > > address 0x42 > > Jun 29 15:07:02 olympus kernel: saa7115: writing init values > > Jun 29 15:07:02 olympus kernel: ivtv: i2c attach [client=saa7115[50],ok] > > Jun 29 15:07:02 olympus kernel: saa7115: status: (1E) 0x48, (1F) 0xc0 > > Jun 29 15:07:02 olympus kernel: saa7127: Ignoring new-style parameters > > in presence of obsolete ones > > Jun 29 15:07:02 olympus kernel: saa7127: video encoder driver version > > V 0.3 loaded > > Jun 29 15:07:02 olympus kernel: saa7127: detecting saa7127 client on > > address 0x88 > > Jun 29 15:07:02 olympus kernel: saa7127: Selecting NTSC video Standard > > Jun 29 15:07:02 olympus kernel: saa7127: Selecting S-Video+Composite > > Jun 29 15:07:02 olympus kernel: saa7127: Turn WSS off > > Jun 29 15:07:02 olympus kernel: saa7127: Widescreen Mode 4:3 Full Format > > Jun 29 15:07:02 olympus kernel: saa7127: Selecting Normal Encoder Input > > Jun 29 15:07:02 olympus kernel: saa7127: Enable Video Output > > Jun 29 15:07:02 olympus kernel: ivtv: i2c attach [client=saa7127[50],ok] > > Jun 29 15:07:02 olympus kernel: ivtv: Failed to load module msp3400 > > Jun 29 15:07:02 olympus kernel: ivtv: Encoder revision: 0x02040024 > > Jun 29 15:07:02 olympus kernel: ivtv: Encoder Firmware may be buggy, > > use version 0x02040011 > > Jun 29 15:07:02 olympus kernel: ivtv: Decoder revision: 0x02020023 > > Jun 29 15:07:02 olympus kernel: ivtv: Configuring WinTV PVR 350 card > > with 10 streams > > Jun 29 15:07:02 olympus kernel: ivtv: Registered v4l2 device for > > encoder MPEG minor 0 > > Jun 29 15:07:02 olympus kernel: ivtv: Create DMA encoder MPEG stream: > > 0 x 32768 buffers (0KB total) > > Jun 29 15:07:03 olympus kernel: ivtv: Registered v4l2 device for > > encoder YUV minor 32 > > Jun 29 15:07:03 olympus kernel: ivtv: Create DMA encoder YUV stream: 0 > > x 12960 buffers (0KB total) > > Jun 29 15:07:03 olympus kernel: ivtv: Registered v4l2 device for > > encoder VBI minor 224 > > Jun 29 15:07:03 olympus kernel: ivtv: Create DMA encoder VBI stream: 0 > > x 12740 buffers (0KB total) > > Jun 29 15:07:03 olympus kernel: ivtv: Registered v4l2 device for > > encoder PCM audio minor 24 > > Jun 29 15:07:03 olympus kernel: ivtv: Create DMA encoder PCM audio > > stream: 0 x 4608 buffers (0KB total) > > Jun 29 15:07:03 olympus kernel: ivtv: Registered v4l2 device for > > encoder radio minor 64 > > Jun 29 15:07:03 olympus kernel: ivtv: Create encoder radio stream > > Jun 29 15:07:03 olympus kernel: ivtv: Registered v4l2 device for > > decoder MPEG minor 16 > > Jun 29 15:07:03 olympus kernel: ivtv: Create DMA decoder MPEG stream: > > 0 x 65536 buffers (0KB total) > > Jun 29 15:07:03 olympus kernel: ivtv: Registered v4l2 device for > > decoder VBI minor 228 > > Jun 29 15:07:03 olympus kernel: ivtv: Create DMA decoder VBI stream: 0 > > x 2048 buffers (0KB total) > > Jun 29 15:07:03 olympus kernel: ivtv: Registered v4l2 device for > > decoder VOUT minor 232 > > Jun 29 15:07:03 olympus kernel: ivtv: Create decoder VOUT stream > > Jun 29 15:07:03 olympus kernel: ivtv: Registered v4l2 device for > > decoder YUV minor 48 > > Jun 29 15:07:03 olympus kernel: ivtv: Create DMA decoder YUV stream: 0 > > x 51840 buffers (0KB total) > > Jun 29 15:07:03 olympus kernel: ivtv: Create DMA decoder OSD stream: 0 > > x 65536 buffers (0KB total) > > Jun 29 15:07:03 olympus kernel: saa7115: decoder set norm PAL > > Jun 29 15:07:03 olympus kernel: saa7115: set audio: 0x01 > > Jun 29 15:07:03 olympus kernel: saa7115: decoder set input (4) > > Jun 29 15:07:03 olympus kernel: saa7115: now setting Composite input > > Jun 29 15:07:03 olympus kernel: ivtv: Setting audio matrix to input 3, > > output 1 > > Jun 29 15:07:03 olympus kernel: ivtv: i2c client addr: 0x40 not found > > for command 0x40086d11! > > Jun 29 15:07:03 olympus kernel: ivtv: i2c client addr: 0x40 not found > > for command 0x80287610! > > Jun 29 15:07:03 olympus kernel: ivtv: i2c client addr: 0x40 not found > > for command 0x40287611! > > Jun 29 15:07:03 olympus kernel: ivtv: Switching standard to PAL. > > Jun 29 15:07:03 olympus kernel: ivtv: i2c client addr: 0x40 not found > > for command 0x40307603! > > Jun 29 15:07:03 olympus kernel: saa7115: decoder set norm PAL > > Jun 29 15:07:04 olympus kernel: saa7115: set audio: 0x01 > > Jun 29 15:07:04 olympus kernel: saa7127: Setting Encoder Video Standard > > Jun 29 15:07:04 olympus kernel: saa7127: Set PAL Video Mode > > Jun 29 15:07:04 olympus kernel: saa7127: Selecting PAL video Standard > > Jun 29 15:07:04 olympus kernel: ivtv: Initialized WinTV PVR 350, card #0 > > Jun 29 15:07:04 olympus kernel: ivtv: ==================== END INIT > > IVTV ==================== > > > > > > ------------------------------------------------------- > > SF.Net email is sponsored by: Discover Easy Linux Migration Strategies > > from IBM. Find simple to follow Roadmaps, straightforward articles, > > informative Webcasts and more! Get everything you need to get up to > > speed, fast. http://ads.osdn.com/?ad_idt77&alloc_id492&op=click > > _______________________________________________ > > ivtv-devel mailing list > > [email protected] > > https://lists.sourceforge.net/lists/listinfo/ivtv-devel > > > > > > > > > > ------------------------------------------------------- > SF.Net email is sponsored by: Discover Easy Linux Migration Strategies > from IBM. Find simple to follow Roadmaps, straightforward articles, > informative Webcasts and more! Get everything you need to get up to > speed, fast. http://ads.osdn.com/?ad_id=7477&alloc_id=16492&op=click > _______________________________________________ > ivtv-devel mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/ivtv-devel >
Neither p or u work for me either. Previous recordings do have audio no problem, but LiveTV or new recordings have no audio, even when playing back through the working 0.2.0 driver. This would lead me to believe it's the audio in that's not working. I will have a look at the ChangeLog and see if I can locate when this might have changed and see if I can locate a working version. Ant. ------------------------------------------------------- SF.Net email is sponsored by: Discover Easy Linux Migration Strategies from IBM. Find simple to follow Roadmaps, straightforward articles, informative Webcasts and more! Get everything you need to get up to speed, fast. http://ads.osdn.com/?ad_idt77&alloc_id492&op=click _______________________________________________ ivtv-devel mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/ivtv-devel
