First some debug data:
##################################### dmsg output
[4294695.207000] ivtv: ==================== START INIT IVTV
====================
[4294695.207000] ivtv: version 0.4.2 (tagged release) loading
[4294695.207000] ivtv: Linux version: 2.6.12-9-k7 K7 gcc-3.4
[4294695.207000] ivtv: In case of problems please include the debug
info between
[4294695.207000] ivtv: the START INIT IVTV and END INIT IVTV lines, along with
[4294695.207000] ivtv: any module options, when mailing the
ivtv-users mailinglist.
[4294695.212000] ivtv0: Autodetected WinTV PVR 150 card (cx23416 based)
[4294695.213000] ACPI: PCI Interrupt Link [APC3] enabled at IRQ 18
[4294695.213000] ACPI: PCI Interrupt 0000:02:08.0[A] -> Link [APC3] ->
GSI 18 (level, high) -> IRQ 18
[4294695.213000] ivtv0: Unreasonably low latency timer, setting to 64 (was 32)
[4294695.242000] ivtv0: i2c attach to card #0 ok [client=tveeprom, addr=50]
[4294695.314000] tveeprom: Hauppauge: model = 23659, rev = D491,
serial# = 8093421
[4294695.314000] tveeprom: tuner = Philips FQ1216AME MK4 (idx = 91, type = 56)
[4294695.314000] tveeprom: tuner fmt = PAL(D/K) (eeprom = 0x74, v4l2 =
0x00400e17)
[4294695.314000] tveeprom: audio_processor = MSP3410D (type = 5)
[4294695.314000] ivtv0: This is the first unit of a PVR500
[4294695.339000] ivtv0: i2c attach to card #0 ok [client=(tuner unset), addr=60]
[4294695.340000] tuner 2-0060: chip found @ 0xc0 (ivtv i2c driver #0)
[4294695.385000] cx25840 2-0044: ivtv driver
[4294695.385000] cx25840 2-0044: cx25843-23 found @ 0x88 (ivtv i2c driver #0)
[4294699.505000] cx25840 2-0044: loaded v4l-cx25840.fw firmware (14264 bytes)
[4294699.587000] ivtv0: i2c attach to card #0 ok [client=cx25840, addr=44]
[4294699.696000] ohci1394: fw-host0: SelfID received outside of bus
reset sequence
[4294699.767000] wm8775 2-001b: ivtv driver
[4294699.767000] wm8775 2-001b: chip found @ 0x36 (ivtv i2c driver #0)
[4294699.779000] ivtv0: i2c attach to card #0 ok [client=wm8775, addr=1b]
[4294699.804000] tda9885/6/7: chip found @ 0x86
[4294699.804000] ivtv0: i2c attach to card #0 ok [client=tda9887, addr=43]
[4294699.974000] ieee1394: Host added: ID:BUS[0-00:1023] GUID[00018013945d64bd]
[4294700.525000] ivtv0: loaded v4l-cx2341x-enc.fw firmware (262144 bytes)
[4294700.735000] ivtv0: Encoder revision: 0x02050032
[4294700.736000] ivtv0: Allocate DMA encoder MPEG stream: 128 x 32768
buffers (4096KB total)
[4294700.737000] ivtv0: Allocate DMA encoder YUV stream: 161 x 12960
buffers (2048KB total)
[4294700.738000] ivtv0: Allocate DMA encoder VBI stream: 80 x 26208
buffers (2048KB total)
[4294700.740000] ivtv0: Allocate DMA encoder PCM audio stream: 455 x
4608 buffers (2048KB total)
[4294700.741000] ivtv0: Create encoder radio stream
[4294700.741000] tuner 2-0060: type set to 56 (Philips PAL/SECAM multi
(FQ1216AME MK4))
[4294700.975000] ivtv0: Initialized WinTV PVR 500 (unit #1), card #0
[4294700.975000] ivtv: ====================== NEXT CARD
======================
[4294700.975000] ivtv1: Autodetected WinTV PVR 150 card (cx23416 based)
[4294700.976000] ACPI: PCI Interrupt Link [APC4] enabled at IRQ 19
[4294700.976000] ACPI: PCI Interrupt 0000:02:09.0[A] -> Link [APC4] ->
GSI 19 (level, high) -> IRQ 19
[4294700.976000] ivtv1: Unreasonably low latency timer, setting to 64 (was 32)
[4294700.978000] ivtv1: i2c attach to card #1 ok [client=tveeprom, addr=50]
[4294701.010000] ivtv1: i2c attach to card #1 ok [client=(tuner unset), addr=61]
[4294701.011000] tuner 3-0061: chip found @ 0xc2 (ivtv i2c driver #1)
[4294701.234000] cx25840 3-0044: ivtv driver
[4294701.235000] cx25840 3-0044: cx25843-23 found @ 0x88 (ivtv i2c driver #1)
[4294705.299000] cx25840 3-0044: loaded v4l-cx25840.fw firmware (14264 bytes)
[4294705.381000] ivtv1: i2c attach to card #1 ok [client=cx25840, addr=44]
[4294705.670000] wm8775 3-001b: ivtv driver
[4294705.670000] wm8775 3-001b: chip found @ 0x36 (ivtv i2c driver #1)
[4294705.682000] ivtv1: i2c attach to card #1 ok [client=wm8775, addr=1b]
[4294705.699000] tda9885/6/7: chip found @ 0x86
[4294705.699000] ivtv1: i2c attach to card #1 ok [client=tda9887, addr=43]
[4294705.773000] tveeprom: Hauppauge: model = 23659, rev = D491,
serial# = 8093421
[4294705.773000] tveeprom: tuner = Philips FQ1216AME MK4 (idx = 91, type = 56)
[4294705.773000] tveeprom: tuner fmt = PAL(D/K) (eeprom = 0x74, v4l2 =
0x00400e17)
[4294705.773000] tveeprom: audio_processor = MSP3410D (type = 5)
[4294705.773000] ivtv1: This is the second unit of a PVR500
[4294705.773000] ivtv1: Correcting tveeprom data: no radio present on
second unit
[4294706.549000] ivtv1: loaded v4l-cx2341x-enc.fw firmware (262144 bytes)
[4294706.759000] ivtv1: Encoder revision: 0x02050032
[4294706.760000] ivtv1: Allocate DMA encoder MPEG stream: 128 x 32768
buffers (4096KB total)
[4294706.761000] ivtv1: Allocate DMA encoder YUV stream: 161 x 12960
buffers (2048KB total)
[4294706.762000] ivtv1: Allocate DMA encoder VBI stream: 80 x 26208
buffers (2048KB total)
[4294706.763000] ivtv1: Allocate DMA encoder PCM audio stream: 455 x
4608 buffers (2048KB total)
[4294706.764000] tuner 3-0061: type set to 56 (Philips PAL/SECAM multi
(FQ1216AME MK4))
[4294706.998000] ivtv1: Initialized WinTV PVR 500 (unit #2), card #1
[4294706.998000] ivtv: ==================== END INIT IVTV
====================
##################################### /dmsg output
##################################### ivtv-detect
[EMAIL PROTECTED]:/etc/modprobe.d# ivtv-detect
driver: ivtv-0.4.2 (tagged release)
card: WinTV PVR 500 (unit #1), bus info 0000:02:08.0, ivtv card #0
hardware: cx25840 tda9887 wm8775 tveeprom
/dev/video0: MPG encoding
/dev/radio0: Radio
/dev/vbi0: VBI encoding
/dev/video24: PCM encoding
/dev/video32: YUV encoding
driver: ivtv-0.4.2 (tagged release)
card: WinTV PVR 500 (unit #2), bus info 0000:02:09.0, ivtv card #1
hardware: cx25840 tda9887 wm8775 tveeprom
/dev/video1: MPG encoding
/dev/vbi1: VBI encoding
/dev/video25: PCM encoding
/dev/video33: YUV encoding
[EMAIL PROTECTED]:/etc/modprobe.d#
##################################### /ivtv-detect
##################################### trying to tune
[EMAIL PROTECTED]:/etc/modprobe.d# ivtv-tune -teurope-west -cE11 -d/dev/video0
/dev/video0: 217.250 MHz
[EMAIL PROTECTED]:/etc/modprobe.d# ivtv-tune -teurope-west -cE11 -d/dev/video1
/dev/video1: 217.250 MHz (Signal Detected)
[EMAIL PROTECTED]:/etc/modprobe.d#
##################################### /trying to tune
My problem is as you can see. The tuner for video0 will not tune. A
test capture with 'cat /dev/video0 > test.mpg' gives only static. A
test capture with 'cat /dev/video1 > test.mpg' gives a clear picture.
Any suggestions?
Regz,
Christian W.
_______________________________________________
ivtv-users mailing list
[email protected]
http://ivtvdriver.org/mailman/listinfo/ivtv-users
