Thomas, This line:
cx25840 1-0044: loaded v4l-cx25840.fw firmware (14264 bytes) Tells me your firmware isn't updated. The new firmware should be 16382 bytes. Please read http://www.ivtvdriver.org/index.php/Firmware and update your firmware. Jonathan >I had mythtv working just fine but then wanted to install mytharchive to >make writing DVDs easier. Mytharchive apparently only installs from >subversion so I had to upgrade my mythtv. I downloaded everything with >subversion and reinstalled. > >While I was at it, I also upgraded to the latest kernel which meant >updating the ivtv drivers. I had been using kernel 2.6.14 with ivtv >0.4.0. I am now on kernel 2.6.16 with ivtv 0.6.3. I run a Gentoo >distribution. > >After upgrading everything, I noticed that the audio through mythtv was >tinny and distorted. Funny thing is if I type 'ivtvctl -c audio=0xe9' >while it is playing, the audio clears up. I have a channel change >script to allow mythtv to control my satellite box and have added some >commands to detect the current audio mode and re-set it when changing >the channel. This fixes my recordings as mythtv will always set the >channel when it starts recording. When watching live tv, I can do this >manually. > >Does this sound like a mythtv problem or an ivtv problem? > >One other thing that's different this time is that I installed ivtv from >the Gentoo package. Before I had always downloaded from the ivtv >website, compiled and installed manually. It may have loaded different >firmware than I had before. > >This is from the last boot. The latency message is nothing new. > >ivtv: ==================== START INIT IVTV ==================== >ivtv: version 0.6.3 (tagged release) loading >ivtv: Linux version: 2.6.16-gentoo-r9 preempt K7 gcc-3.4 >ivtv: In case of problems please include the debug info between >ivtv: the START INIT IVTV and END INIT IVTV lines, along with >ivtv: any module options, when mailing the ivtv-users mailinglist. >ivtv0: Autodetected Hauppauge WinTV PVR-150 card (cx23416 based) >ACPI: PCI Interrupt 0000:00:0a.0[A] -> Link [LNKC] -> GSI 5 (level, low) >-> IRQ 5 >ivtv0: Unreasonably low latency timer, setting to 64 (was 32) >tveeprom 1-0050: Hauppauge model 26552, rev B268, serial# 7954188 >tveeprom 1-0050: tuner model is LG TAPE H001F MK3 (idx 68, type 47) >tveeprom 1-0050: TV standards NTSC(M) (eeprom 0x08) >tveeprom 1-0050: audio processor is CX25843 (idx 37) >tveeprom 1-0050: decoder processor is CX25843 (idx 30) >tveeprom 1-0050: has radio, has no IR remote >tuner 1-0061: chip found @ 0xc2 (ivtv i2c driver #0) >tda9887 1-0043: chip found @ 0x86 (ivtv i2c driver #0) >cx25840 1-0044: cx25843-23 found @ 0x88 (ivtv i2c driver #0) >cx25840 1-0044: loaded v4l-cx25840.fw firmware (14264 bytes) >wm8775 1-001b: chip found @ 0x36 (ivtv i2c driver #0) >ivtv0: loaded v4l-cx2341x-enc.fw firmware (262144 bytes) >ivtv0: Encoder revision: 0x02050032 >ivtv0: Allocate DMA encoder MPEG stream: 128 x 32768 buffers (4096KB total) >ivtv0: Allocate DMA encoder YUV stream: 194 x 10800 buffers (2048KB total) >ivtv0: Allocate DMA encoder VBI stream: 120 x 17472 buffers (2048KB total) >ivtv0: Allocate DMA encoder PCM audio stream: 455 x 4608 buffers (2048KB >total) >ivtv0: Create encoder radio stream >tuner 1-0061: type set to 47 (LG NTSC (TAPE series)) >ivtv0: Initialized Hauppauge WinTV PVR-150, card #0 >ivtv: ==================== END INIT IVTV ==================== > > > _______________________________________________ ivtv-users mailing list [email protected] http://ivtvdriver.org/mailman/listinfo/ivtv-users
