Selec
On Friday 08 September 2006 20:52, [EMAIL PROTECTED] wrote:
> I have recently installed a second pvr-150 in my myth system and the
> second tuner will NOT autodetect. I am running Debian Sarge 2.6.17
> kernel with ivtv 0.7.0. I have upgraded and recompiled everything
> including the firmware per your website. In addition to not
> autodetecting it will not let me set the tuner via an options clause
> in the modprobe, providing the option in the ivtv file in modprobe.d,
> or the two distro specific config files.
>
> The second tuner only gives me a black screen with colored diagnal
> streaks. It appears to change channels properly and the audio comes
> out as white noise/static.
>
> Placing a line in modules:
> ivtv tuner=50
> or
> ivtv options tuner=50
That should be:
options ivtv tuner=50
This tuner is autodetected in the upcoming 2.6.18 kernel.
Hans
> only resulted in the driver not finding the firmware file to load at
> runtime so nothing works.
>
>
> Here is my dmesg output:
> ivtv: ==================== START INIT IVTV ====================
> ivtv: version 0.7.0 (tagged release) loading
> ivtv: Linux version: 2.6.17-chw-8 SMP preempt mod_unload 586 gcc-3.4
> ivtv: In case of problems please include the debug info between
> ivtv: the START INIT IVTV and END INIT IVTV lines, along with
> ivtv: any module options, when mailing the ivtv-users mailinglist.
> ivtv0: Autodetected Hauppauge WinTV PVR-150 card (cx23416 based)
> ACPI: PCI Interrupt 0000:00:0a.0[A] -> GSI 18 (level, low) -> IRQ 22
> tuner 0-0061: chip found @ 0xc2 (ivtv i2c driver #0)
> cx25840 0-0044: cx25843-23 found @ 0x88 (ivtv i2c driver #0)
> cx25840 0-0044: loaded v4l-cx25840.fw firmware (16382 bytes)
> wm8775 0-001b: chip found @ 0x36 (ivtv i2c driver #0)
> tveeprom 0-0050: Hauppauge model 26052, rev C599, serial# 8805504
> tveeprom 0-0050: tuner model is TCL 2002N 5H (idx 99, type 50)
> tveeprom 0-0050: TV standards NTSC(M) (eeprom 0x08)
> tveeprom 0-0050: audio processor is CX25843 (idx 37)
> tveeprom 0-0050: decoder processor is CX25843 (idx 30)
> tveeprom 0-0050: has no radio, has IR remote
> eth0: no IPv6 routers present
> eth1: no IPv6 routers present
> ivtv0: loaded v4l-cx2341x-enc.fw firmware (262144 bytes)
> ivtv0: Encoder revision: 0x02050032
> ivtv0: Allocate DMA encoder MPEG stream: 128 x 32768 buffers (4096KB
> total) ivtv0: Allocate DMA encoder YUV stream: 194 x 10800 buffers
> (2048KB total) ivtv0: Allocate DMA encoder VBI stream: 120 x 17472
> buffers (2048KB total) ivtv0: Allocate DMA encoder PCM audio stream:
> 455 x 4608 buffers (2048KB total) tuner 0-0061: type set to 50 (TCL
> 2002N)
> ivtv0: Initialized Hauppauge WinTV PVR-150, card #0
> ivtv: ====================== NEXT CARD ======================
> ivtv1: Autodetected Hauppauge WinTV PVR-150 card (cx23416 based)
> ACPI: PCI Interrupt 0000:00:0c.0[A] -> GSI 16 (level, low) -> IRQ 17
> tuner 1-0061: chip found @ 0xc2 (ivtv i2c driver #1)
> cx25840 1-0044: cx25841-23 found @ 0x88 (ivtv i2c driver #1)
> cx25840 1-0044: loaded v4l-cx25840.fw firmware (16382 bytes)
> wm8775 1-001b: chip found @ 0x36 (ivtv i2c driver #1)
> tveeprom 1-0050: Hauppauge model 26132, rev F0B2, serial# 9399761
> tveeprom 1-0050: tuner model is TCL M2523_5N_E (idx 112, type 4)
> tveeprom 1-0050: TV standards NTSC(M) (eeprom 0x08)
> tveeprom 1-0050: audio processor is CX25841 (idx 35)
> tveeprom 1-0050: decoder processor is CX25841 (idx 28)
> tveeprom 1-0050: has no radio, has IR remote
> ivtv1: loaded v4l-cx2341x-enc.fw firmware (262144 bytes)
> ivtv1: Encoder revision: 0x02050032
> ivtv1: Allocate DMA encoder MPEG stream: 128 x 32768 buffers (4096KB
> total) ivtv1: Allocate DMA encoder YUV stream: 194 x 10800 buffers
> (2048KB total) ivtv1: Allocate DMA encoder VBI stream: 120 x 17472
> buffers (2048KB total) ivtv1: Allocate DMA encoder PCM audio stream:
> 455 x 4608 buffers (2048KB total) tuner 1-0061: tuner type not set
> tuner 1-0061: tuner type not set
> ivtv1: Initialized Hauppauge WinTV PVR-150, card #1
> ivtv: ==================== END INIT IVTV ====================
>
>
> Oddly enough this output was generated with the following
> /etc/modprobe.d/ivtv file in place
> alias char-major-81 videodev
> alias char-major-81-0 ivtv
> alias char-major-81-1 ivtv
> options ivtv tuner=50
>
>
> This is per your website at
> http://www.ivtvdriver.org/index.php/Howto#Module_options
>
> I have also tried it without the alias lines.
>
> I have tried the following tuner numbers with no success (per many
> different websites):
> 0,4,39,43,47,49,50
>
> I have also tried renaming the above file to /etc/modprobe.d/ivtv1 to
> designate the second tuner and have tried with all the different
> combinations of tuner numbers.
>
> Unfortunately I could find no clear documentation on your site as to
> the structure of the config file for multiple tuners.
>
> I then upgraded my knoppmyth distro to R5D1 which was released a
> couple weeks ago. With this distro there are two other possible
> configuration files. One is the /etc/mythtv/modules/ivtv1 (for the
> second tuner) to which I added the same options line as the
> /etc/modprobe.d/ivtv file (supposed to be the same syntax). Then
> there is the /etc/sysconfig/ivtv/cfg-1 (again the 1 for the second
> card) and uncommented out the ivtv_tuner line. Again I tried with
> all the different tuner numbers.
>
> I also made sure all these files contained the same values at all
> times. Of course trying for each of the above listed tuner values.
>
> I also have made sure I have not used Mythtv to test the tuner. I
> have used the command line tools as per your troubleshooting guide.
> All with the same results.
>
> I have checked for IRQ conflicts and there are none. I have even
> tried putting the cards in different pci slots but every time I get
> the same result.
>
> I have seen on the list that the tuner type of 4 with an idx of 112
> have been successfully configured and are in use I do not understand
> why my system refuses to recognize the second tuner automatically. I
> also do not understand why it refuses to be force configured as many
> on the list have had to do.
>
> My first tuner card is unaffected by the upgrade and I can still
> watch/record/etc. with the single tuner.
>
> Andre
>
> _______________________________________________
> ivtv-users mailing list
> [email protected]
> http://ivtvdriver.org/mailman/listinfo/ivtv-users
_______________________________________________
ivtv-users mailing list
[email protected]
http://ivtvdriver.org/mailman/listinfo/ivtv-users
