Hi Richard, I just had a look at the schematics. - Why do you use such a low value pull-up on the reset and a diode? - You mentioned jumpers before for comms selection, but I thought that you would jumper the desired signal to the connector. Now I see that you use is to indicate the software which code to run. My intention was to run both serial and i2c at the same time. Would that work or should we make it selectable? - If you want do not ty Vee to ground, would it add value when you put a potmeter in?
Joep --~--~---------~--~----~------------~-------~--~----~ You received this message because you are subscribed to the Google Groups "jallib" group. To post to this group, send email to [email protected] To unsubscribe from this group, send email to [email protected] For more options, visit this group at http://groups.google.com/group/jallib?hl=en -~----------~----~----~----~------~----~------~--~---
