funlw65 wrote: > In the past I worked with jallib 0.2.0, serial software and 12f675 at > 4MHz internal with a maximum of 4800bps without garbage characters (of > course, OSCCAL had to be setup at factory settings): > http://sites.google.com/site/funlw65/electronics/windmill-controller-with-pic12f675 >
Thanks for that link Vasi. I seems we have similar interests. The 12f509 project I had in mind is to measure the temperature in my outside battery box and switch my wind mill to power some 12 volt heaters. The more that I look at it I think the 509 may not be enough chip :-) There is a lot more I want to do, now. > For 9600bps you need a minimum of 8MHz clock frequency. And is working > even if is about internal clock (it needs a correct osccal if that is > required). I read somewhere (I read a lot but never remember where I read it), that a 1.8432 MHz crystal would be a good choice for 9600 baud. Many Thanks Wayne --~--~---------~--~----~------------~-------~--~----~ You received this message because you are subscribed to the Google Groups "jallib" group. To post to this group, send email to [email protected] To unsubscribe from this group, send email to [email protected] For more options, visit this group at http://groups.google.com/group/jallib?hl=en -~----------~----~----~----~------~----~------~--~---
