Yes, that is what I meant. Matt.
On May 21, 5:26 pm, funlw65 <[email protected]> wrote: > I think he saying that if is possible to take the assembler code > produced by a C compiler for other targets and to put it in JALv2 for > good. And then use JALv2 exclusively. If entire Jallib code is > translated in assembler for Cortex (e.g.), then that assembler can be > stored in JALv2 compiler, so, Kyle don't need to waste time and > resources to learn a new assembler for a new target. And you don't > need anymore the translator and the C compiler - just once. > I understood right Matt? > > Vasi(funlw65) > > On May 21, 11:03 pm, Joep Suijs <[email protected]> wrote: > > > > > Hi Matt, > > > 2010/5/21 mattschinkel <[email protected]>: > > > > One suggestion I had was to take the resulting ASM from Joep's project > > > and place it into the JalV2 Compiler. I know nothing about this stuff > > > however, but if it is possible it may save you from writing too much > > > ASM. > > > I'm afraid I don't understand what you suggest. > > The translator outputs C that can be fed into a C compiler. If you put > > this into the pic18 C-compiler the output will run on an 18F chip, but > > the code will be slower and probably larger then the code generated by > > the JAL compiler (apart from language conformance and quality). > > > Joep > > > -- > > You received this message because you are subscribed to the Google Groups > > "jallib" group. > > To post to this group, send email to [email protected]. > > To unsubscribe from this group, send email to > > [email protected]. > > For more options, visit this group > > athttp://groups.google.com/group/jallib?hl=en. > > -- > You received this message because you are subscribed to the Google Groups > "jallib" group. > To post to this group, send email to [email protected]. > To unsubscribe from this group, send email to > [email protected]. > For more options, visit this group > athttp://groups.google.com/group/jallib?hl=en. -- You received this message because you are subscribed to the Google Groups "jallib" group. To post to this group, send email to [email protected]. To unsubscribe from this group, send email to [email protected]. For more options, visit this group at http://groups.google.com/group/jallib?hl=en.
