Hi Seb,
On 2011/04/10 11:42, Sebastien Lelong wrote:
2011/4/10 Rob Hamerling <[email protected]
In the new library I try to mimic the functionality of 'traditional'
alarm clocks. I've committed it for you, but need some more tests to
see if everything works as intended (and is intuitive).
OK, I'll have a look !
I'll commit my sample using the new library soon. May help!
The board I have was meant for a 18f26j11. I replaced the chip with
a 18f27j53 (for exchange with you), but it doesn't run. I have not
found why...
Rechecked again, it works. Carefull I'm using 16Mhz Xtal running PLL. I
think your setup is different regarding this.
I have found the trouble. The clock runs OK, but I have connected a 3x4
keyboard to this board and 2 of the drive lines are on pin_C4 and
pin_C5, which appear to be input only on the 18f27j53! So I cannot
change times, etc. via the keyboard. So for the moment I forget the
18f27j53 for my clock!
Regards, Rob.
--
R. Hamerling, Netherlands --- http://www.robh.nl
--
You received this message because you are subscribed to the Google Groups
"jallib" group.
To post to this group, send email to [email protected].
To unsubscribe from this group, send email to
[email protected].
For more options, visit this group at
http://groups.google.com/group/jallib?hl=en.
