Hello Folks
I dropped off the jess list for a while so I'm sorry if this topic
has been beaten to death already. I couldn't find much in the archives
though.
I would like to use Jess in a real-time control system to monitor
parameters from physical devices like power supplies, pumps, magnets
etc. I have writen a few clip files as part of a pilot project to test
the fesability. I was showing the clip to someone and their comment was
"I hope you don't expect our users to learn this!". It's a valid point.
I think I understand clip/Jess but the language itself is rather
cryptic. Is there any "natural language" method out there which would
allow us to write rules and facts in a way which a non-expert can
understand. I could probably get someone in my group to work on it but,
obviously, would rather start with something which already exists.
Regards,
Graham
-------------------------------------------------------------------------------
Beware of Geeks bearing GIFS. http://coda.jlab.org/ Jefferson lab DAQ
group
---------------------------------------------------------------------
To unsubscribe, send the words 'unsubscribe jess-users [EMAIL PROTECTED]'
in the BODY of a message to [EMAIL PROTECTED], NOT to the
list (use your own address!) List problems? Notify [EMAIL PROTECTED]
---------------------------------------------------------------------
