Try using properties for the config data instead of variables.
On 03/07/06, eric craven <[EMAIL PROTECTED]> wrote:
i would like to read in a config file before any thread group is run, set a few variables that are valid for all thread groups, and then, after all thread groups have finished, write back some of these variables to a file.. i have to use beanshell for this :) i ran into the following problems: * vars.put does not set a variable for anything *outside* the current thread group * i cannot have any beanshell scripts outside a thread group * is there any way i can access the current loop counter for the current thread group? * is there a way to run a beanshell script at a certain point in the tree, for side effects? not a sampler, not a function, just run a script? thanks for any help! eric --------------------------------------------------------------------- To unsubscribe, e-mail: [EMAIL PROTECTED] For additional commands, e-mail: [EMAIL PROTECTED]
--------------------------------------------------------------------- To unsubscribe, e-mail: [EMAIL PROTECTED] For additional commands, e-mail: [EMAIL PROTECTED]
