Thanks Aaron. I believe this config is enough for filter 'all'.
firewall { filter all { term all { then { sample; accept; } } } } What do u say? Regards Farhan Jaffer On 12/16/06, Aaron Dewell <[EMAIL PROTECTED]> wrote: > > > Do you have a firewall filter named "all" configured? > > Aaron > > On Sat, 2006-12-16 at 13:04 +0500, Farhan Jaffer wrote: > > I want to configure netflow on Juniper M7i having Junos version > 7.6R1.10, > > just like ip flow-export & ip route-cache flow (related) commands in > Cisco > > IOS. Also i like to enable cache flow or ip accounting on any fast > ethernet > > interface when needed. > > Kindly help me to solve this. > > > > I have configured router for netflow feature using these command, but it > > didn't work > > > > interfaces { > > fe-0/3/0 { > > unit 0 { > > family inet { > > filter { > > input all; > > output all; > > } > > address 10.0.0.1/24; > > } > > } > > } > > > > firewall { > > filter all { > > term all { > > then { > > sample; > > accept; > > } > > } > > } > > } > > > > forwarding-options { > > sampling { > > input { > > family inet { > > rate 100; > > } > > } > > output { > > cflowd 10.0.0.100 { > > port 9800; > > version 5; > > } > > } > > } > > } > > > > Any comments ?? > > > > Thanks in advance. > > > -- > Aaron Dewell > Sr. Network/Systems Consultant > Woods Networking Consultants, Inc. > +1.408.857.0778 > [EMAIL PROTECTED] > > > _______________________________________________ juniper-nsp mailing list juniper-nsp@puck.nether.net https://puck.nether.net/mailman/listinfo/juniper-nsp