Hi, Your use of tcc encaps on the interfaces is probably the issue. Since you've told l2vpn that your encaps is for vlan, you should be using vlan-ccc for interface encaps. TCC is usually used for FR to ATM, ATM to Eth, etc. I could be wrong here but give it a shot.
LDP vs RSVP tunnels. L2vpn is kompella, so mp-bgp is setting up parameters on control plane, should just use any tunnel as long as there is an entry in inet.3 for the remote pe router-id, regardless of signaling used. HTHs Jake Bourgeois -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Telmo Javier Di Leva Sent: Wednesday, February 07, 2007 2:32 PM To: juniper-nsp@puck.nether.net Subject: [j-nsp] L2VPN config sample! Dears all.... I'm contacting you, because, we are trying to configure an L2VPN on a JM20. Basically the configuration is the following: Pe2> show configuration routing-instances L2VPN instance-type l2vpn; interface ge-1/1/0.195; route-distinguisher 18747:5555555555; vrf-target target:18747:5555555555; protocols { l2vpn { encapsulation-type ethernet-vlan; site US { site-identifier 2; interface ge-1/1/0.195 { remote-site-id 1; } } } } JM20x2> Pe1> show configuration routing-instances L2VPN instance-type l2vpn; interface ge-0/2/0.195; route-distinguisher 18747:5555555555; vrf-target target:18747:5555555555; protocols { l2vpn { traceoptions { file VPLS.log; flag all; } encapsulation-type ethernet-vlan; site AR { site-identifier 1; interface ge-0/2/0.195 { remote-site-id 2; } } } } The encapsulation for the interfaces are TCC: > show configuration interfaces ge-0/2/0.195 encapsulation vlan-tcc; vlan-id 195; In both routers the BGP configuration have family l2vpn unicast whit junos 7.0R2.7. In addition between every router we have 2 packet over sonet interfaces stm1, and the route table for l2vpn is the following: Pe1> show route table l2vpn L2VPN.l2vpn.0: 1 destinations, 1 routes (1 active, 0 holddown, 0 hidden) Restart Complete + = Active Route, - = Last Active, * = Both 18747:4294967295:1:1/96 *[L2VPN/7] 00:17:20 Discard Pe2>> show route table L2VPN L2VPN.l2vpn.0: 1 destinations, 1 routes (1 active, 0 holddown, 0 hidden) + = Active Route, - = Last Active, * = Both 18747:4294967295:2:1/96 *[L2VPN/7] 00:17:57 Discard Can sombody help me? whats wrong in the configuration? All examples on Juniper Site use TE whit RSVP, and we are using LDP to exchange labels. Best Regards. _______________________________________________ juniper-nsp mailing list juniper-nsp@puck.nether.net https://puck.nether.net/mailman/listinfo/juniper-nsp _______________________________________________ juniper-nsp mailing list juniper-nsp@puck.nether.net https://puck.nether.net/mailman/listinfo/juniper-nsp