Hi!

So, i have tried it today. I failed. I had put in a formatted compact flash, and I think that that was my failure, as the boot sequence was stuck on the compact flash medium. So the compact flash must not be formatted, it has to be blank, i.e. no partitions on it?

Regards,

Matthias

Am 03.03.2009 um 16:39 schrieb David Ball:

 Once installed, your router won't boot from it, since it's blank, so
will boot from HD as normal.  Then you should be able to issue
'request system snapshot partition' (ie. copy main contents of hard
disk to flash drive).  From that point on, the CF will be your primary
boot medium.  Any code upgrades from then on will occur on the CF
card, so to back up that code and config in the future, you'd issue
'request system snapshot' to copy them to the HD, which is now your
'alternative' boot medium.

David

2009/3/3 Matthias Gelbhardt <matth...@commy.de>:
Hi!

I would like to add a new 1 GB CF card in a M7i. I assume, there is none in
that device at the moment:

Filesystem Size Used Avail Capacity Mounted on
/dev/ad1s1a             217M        98M       102M       49%  /
devfs                   1.0K       1.0K         0B      100%  /dev
devfs                   1.0K       1.0K         0B      100%  /dev/
/dev/md0                 23M        23M         0B      100%
 /packages/mnt/jbase
/dev/md1                 80M        80M         0B      100%
 /packages/mnt/jkernel-8.5R3.4
/dev/md2                8.8M       8.8M         0B      100%
 /packages/mnt/jpfe-M7i-8.5R3.4
/dev/md3                3.5M       3.5M         0B      100%
 /packages/mnt/jdocs-8.5R3.4
/dev/md4                 28M        28M         0B      100%
 /packages/mnt/jroute-8.5R3.4
/dev/md5                8.8M       8.8M         0B      100%
 /packages/mnt/jcrypto-8.5R3.4
/dev/md6                 37M        37M         0B      100%
 /packages/mnt/jpfe-common-8.5R3.4
/dev/md7                504M       8.0K       463M        0%  /tmp
/dev/md8                504M       470K       463M        0%  /mfs
/dev/ad1s1e              24M        20K        22M        0%  /config
procfs                  4.0K       4.0K         0B      100%  /proc
/dev/ad1s1f              18G       542M        16G        3%  /var

So I need one to update to 9.3R2.

Do I have to prepare the CF before injecting it into the router? Does it
have to be formatted?

Regards,

Matthias
_______________________________________________
juniper-nsp mailing list juniper-nsp@puck.nether.net
https://puck.nether.net/mailman/listinfo/juniper-nsp


_______________________________________________
juniper-nsp mailing list juniper-nsp@puck.nether.net
https://puck.nether.net/mailman/listinfo/juniper-nsp

Reply via email to