Have a look at http://www.juniper.net/techpubs/software/junos-es/junos-es92/junos-es-swconfig-interfaces-and-routing/configuring-a-route-reflector-optional.html
// Olof On Wed, Oct 7, 2009 at 7:30 AM, a.r.isnaini.rangkayo.st <risna...@netsoft.net.id> wrote: > Hallo, > > > I'm trying to simply re-advertise some prefixes in a 3 iBGP speakers serial > topology. > Second router [in the middle] should set both 1rst & 3rd routers as > reflector client. > Does the process just simply add this command in second router ?. > > If so then, I didn't see that my engine supports this command. > Or I missed another pre-step to have this command to appear. > > Thanks in Advance > a. rahman isnaini r.sutan > > > # set neighbor 192.168.24.109 ? > Possible completions: > <[Enter]> Execute this command > advertise-inactive Advertise inactive routes > advertise-peer-as Advertise routes received from the same autonomous > system > + apply-groups Groups from which to inherit configuration data > + apply-groups-except Don't inherit configuration data from these groups > as-override Replace neighbor AS number with our AS number > authentication-key MD5 authentication key > cluster Cluster identifier > damping Enable route flap damping > description Text description > + export Export policy >> family Protocol family for NLRIs in updates >> graceful-restart BGP graceful restart options > hold-time Hold time used when negotiating with a peer (6..65535) > + import Import policy > include-mp-next-hop Include NEXT-HOP attribute in multiprotocol updates > ipsec-sa IPSec SA name > keep How to retain routes in the routing table > local-address Address of local end of BGP session >> local-as Local autonomous system number > local-interface Local interface for IPv6 link local EBGP peering > local-preference Value of LOCAL_PREF path attribute > log-updown Log a message for peer state transitions >> metric-out Route metric sent in MED > mtu-discovery Enable TCP path MTU discovery >> multihop Configure an EBGP multihop session > multipath Allow load sharing among multiple BGP paths > no-advertise-peer-as Don't advertise routes received from the same > autonomous system > no-aggregator-id Set router ID in aggregator path attribute to 0 > no-client-reflect Disable intracluster route redistribution > out-delay How long before exporting routes from routing table > passive Do not send open messages to a peer > peer-as Peer autonomous system number (1..65535) > preference Preference value > remove-private Remove well-known private AS numbers >> traceoptions Trace options for BGP > vpn-apply-export Apply BGP export policy when exporting VPN routes > | Pipe through a command > _______________________________________________ > juniper-nsp mailing list juniper-nsp@puck.nether.net > https://puck.nether.net/mailman/listinfo/juniper-nsp > _______________________________________________ juniper-nsp mailing list juniper-nsp@puck.nether.net https://puck.nether.net/mailman/listinfo/juniper-nsp