Hi, We have installed EX3200 with Cisco 3750, its working gr8. Two things, statically configure duplex and speed on both switches. Turn off keepalive on cisco interface connected to juniper switch or statically configure keepalive on both switches for e.g 5 sec., keepalive do cause problem when integrating, cisco-juniper equipment.
Regards, Muhammad Jawwad Paracha ________________________________ From: "techt...@gmail.com" <techt...@gmail.com> To: juniper-nsp@puck.nether.net Sent: Tue, October 13, 2009 10:44:26 AM Subject: [j-nsp] EX3200 Interop with Cisco 4948 Hi, I have recently installed an EX-3200 for one of our customers and connected it to a Cisco Catalyst 4948 switch. Both are 10/100/1000Mbps switches and are inter-connected with copper wire, based on the defaults they supposed to sync on 1G But for some reason they are sync on 100Mbps half?! I have tried every combination and setting (speed/duplex) but I never succeeded to pass over 100m full. Does someone have any ideas regarding this issue? Best Regards, MTC _______________________________________________ juniper-nsp mailing list juniper-nsp@puck.nether.net https://puck.nether.net/mailman/listinfo/juniper-nsp _______________________________________________ juniper-nsp mailing list juniper-nsp@puck.nether.net https://puck.nether.net/mailman/listinfo/juniper-nsp