Have you swapped out the cable? Gigabit spec will downshift if one of the pairs is open.
-b -----Original Message----- From: juniper-nsp-boun...@puck.nether.net [mailto:juniper-nsp-boun...@puck.nether.net] On Behalf Of techt...@gmail.com Sent: Monday, October 12, 2009 10:44 PM To: juniper-nsp@puck.nether.net Subject: [j-nsp] EX3200 Interop with Cisco 4948 Hi, I have recently installed an EX-3200 for one of our customers and connected it to a Cisco Catalyst 4948 switch. Both are 10/100/1000Mbps switches and are inter-connected with copper wire, based on the defaults they supposed to sync on 1G But for some reason they are sync on 100Mbps half?! I have tried every combination and setting (speed/duplex) but I never succeeded to pass over 100m full. Does someone have any ideas regarding this issue? Best Regards, MTC _______________________________________________ juniper-nsp mailing list juniper-nsp@puck.nether.net https://puck.nether.net/mailman/listinfo/juniper-nsp _______________________________________________ juniper-nsp mailing list juniper-nsp@puck.nether.net https://puck.nether.net/mailman/listinfo/juniper-nsp