Ramesh Karki wrote: > Hello all, > > We are facing some issues on Juniper M10i, i.e. > > First, we had to hard reset the bgp peer whenever we change the policies > (inbound policy) that we had set. By just doing soft reset the router will > not take effect of that changed policies until we do hard reset. Sometimes > even after hard reset, some strange issue were faced as for command:- > > # sh bgp summary - > > shows the peer is established but the line Active/Received/Accepted shows > 0/0/0 respectively. However, we can view the received route on BGP table but > it does not announce any prefixes towards that peer for return traffic. Last > time when we had deactivated BGP, it wasn't updated-( BGP remained active). > Only after rebooting the RE, the router operates as configured. > > If anyone has faced similar issue, I would appreciated any sort of help in > this regard. > we had identical symptoms on an MX960 a couple months back. "restart routing" was required. This was the first & last time we saw this. I think we were on 9.3R2.8 back then.
Kind regards, Felix -- Felix Schüren Head of Network ----------------------------------------------------------------------- Host Europe GmbH - http://www.hosteurope.de Welserstraße 14 - 51149 Köln - Germany Telefon: 0800 467 8387 - Fax: +49 180 5 66 3233 (*) HRB 28495 Amtsgericht Köln - USt-IdNr.: DE187370678 Geschäftsführer: Uwe Braun - Alex Collins - Mark Joseph - Patrick Pulvermüller (*) 0,14 EUR/Min. aus dem dt. Festnetz, Mobilfunkpreise ggf. abweichend _______________________________________________ juniper-nsp mailing list juniper-nsp@puck.nether.net https://puck.nether.net/mailman/listinfo/juniper-nsp