Thank you all. It is installed and working ;) Regards, Junaid
On Wed, Dec 16, 2009 at 1:55 PM, Martin Levin <martin.le...@molndal.se> wrote: > Yes, It does if the SFP is Juniper original (or coded as original). This > is from 10.0 and onwards, before that DOM doesn't exist on an EX. > > --- > Martin Levin > IT-strategy & planning > Mölndals stad > > >>>> > > > Från:"Jay Hanke" <jha...@myclearwave.net> > Till:"'Chuck Anderson'" <c...@wpi.edu>, <juniper-nsp@puck.nether.net> > Datum:2009-12-16 01:02 > Ärende:Re: [j-nsp] Juniper 10GE XFP > Does it also work on a non uplink module ie EX 4200-24F? > > -----Original Message----- > From: juniper-nsp-boun...@puck.nether.net > [mailto:juniper-nsp-boun...@puck.nether.net] On Behalf Of Chuck > Anderson > Sent: Tuesday, December 15, 2009 4:41 PM > To: juniper-nsp@puck.nether.net > Subject: Re: [j-nsp] Juniper 10GE XFP > > On Mon, Dec 14, 2009 at 03:53:16PM -0600, Jay Hanke wrote: >> The EX is a different animal, I think there is only support for DOM >> on the XFP ports unlike the MX where it is supported on all the SFP >> and XFP ports. Also, I think DOM support is recent (10.0?) on the >> EX. > > No, DOM works on SFP on EX4200 with 10.0. > > ex4200> show interfaces diagnostics optics ge-0/1/0 > Physical interface: ge-0/1/0 > Laser bias current : 23.140 mA > Laser output power : 0.2170 mW / -6.64 dBm > Module temperature : 47 degrees C / 117 > degrees > F > Module voltage : 3.2470 V > Receiver signal average optical power : 0.0006 mW / -32.22 > dBm > Laser bias current high alarm : Off > Laser bias current low alarm : Off > Laser bias current high warning : Off > Laser bias current low warning : Off > Laser output power high alarm : Off > Laser output power low alarm : Off > Laser output power high warning : Off > Laser output power low warning : Off > Module temperature high alarm : Off > Module temperature low alarm : Off > Module temperature high warning : Off > Module temperature low warning : Off > Module voltage high alarm : Off > Module voltage low alarm : Off > Module voltage high warning : Off > Module voltage low warning : Off > Laser rx power high alarm : Off > Laser rx power low alarm : On > Laser rx power high warning : Off > Laser rx power low warning : Off > Laser bias current high alarm threshold : 79.998 mA > Laser bias current low alarm threshold : 0.000 mA > Laser bias current high warning threshold : 69.998 mA > Laser bias current low warning threshold : 3.998 mA > Laser output power high alarm threshold : 0.7940 mW / -1.00 dBm > Laser output power low alarm threshold : 0.0790 mW / -11.02 > dBm > Laser output power high warning threshold : 0.6300 mW / -2.01 dBm > Laser output power low warning threshold : 0.1000 mW / -10.00 > dBm > Module temperature high alarm threshold : 85 degrees C / 185 > degrees > F > Module temperature low alarm threshold : -5 degrees C / 23 > degrees F > Module temperature high warning threshold : 80 degrees C / 176 > degrees > F > Module temperature low warning threshold : 0 degrees C / 32 > degrees F > Module voltage high alarm threshold : 3.599 V > Module voltage low alarm threshold : 3.000 V > Module voltage high warning threshold : 3.499 V > Module voltage low warning threshold : 3.100 V > Laser rx power high alarm threshold : 0.7943 mW / -1.00 dBm > Laser rx power low alarm threshold : 0.0079 mW / -21.02 > dBm > Laser rx power high warning threshold : 0.6309 mW / -2.00 dBm > Laser rx power low warning threshold : 0.0099 mW / -20.04 > dBm > > > ex4200> show interfaces ge-0/1/0 terse > Interface Admin Link Proto Local > Remote > ge-0/1/0 up down > ge-0/1/0.0 up down eth-switch > > ex4200> show chassis hardware > ... > PIC 0 BUILTIN BUILTIN 48x > 10/100/1000 > Base-T > PIC 1 REV 04 711-026017 ............ 4x GE SFP+ > Xcvr 0 REV 01 740-011614 ......... SFP-LX10 > > > ex4200> show chassis pic fpc-slot 0 pic-slot 1 > FPC slot 0, PIC slot 1 information: > Type 4x GE SFP+ > State Online > PIC version 1.4 > Uptime 18 hours, 12 minutes, 48 seconds > > PIC port information: > Fiber Xcvr vendor > Port Cable type type Xcvr vendor part number > Wavelength > 0 GIGE 1000LX10 SM OPNEXT INC TRF5736AALB214 > 1310 nm > > _______________________________________________ > juniper-nsp mailing list juniper-nsp@puck.nether.net > https://puck.nether.net/mailman/listinfo/juniper-nsp > > _______________________________________________ > juniper-nsp mailing list juniper-nsp@puck.nether.net > https://puck.nether.net/mailman/listinfo/juniper-nsp > _______________________________________________ > juniper-nsp mailing list juniper-nsp@puck.nether.net > https://puck.nether.net/mailman/listinfo/juniper-nsp -- Regards, Junaid _______________________________________________ juniper-nsp mailing list juniper-nsp@puck.nether.net https://puck.nether.net/mailman/listinfo/juniper-nsp