Mixed mode is not supported on an srx.
For a layer 3 ip you have to use an irb interface. This is non-routable so it
may not be what you're looking for. It's used for management of the device
typically. At best it's an ip to ping.
On May 31, 2012, at 12:59 AM, Per Granath <per.gran...@gcc.com.cy> wrote:
> Try adding:
>
> set interfaces reth0 encapsulation flexible-ethernet-services
>
>
>> I try to have a vlan 200 in layer 2 mode transparent accross the SRX in
>> failover
>> mode.
>> Is it possible to have a redundant interface as trunk link, with 1 vlan
>> with an
>> @IP, and 1 vlan in transparent mode.
>>
>>
>> I give you my config:
>> ===============
>> reth0 {
>> description "TRUNK vers RAP";
>> vlan-tagging;
>> redundant-ether-options {
>> redundancy-group 1;
>> }
>> unit 200 {
>> family bridge {
>> interface-mode trunk;
>> vlan-id-list 200;
>> }
>> }
>> unit 954 {
>> vlan-id 954;
>> family inet {
>> address 195.221.127.158/30;
>> }
>> }
>> }
>
>
> _______________________________________________
> juniper-nsp mailing list juniper-nsp@puck.nether.net
> https://puck.nether.net/mailman/listinfo/juniper-nsp
_______________________________________________
juniper-nsp mailing list juniper-nsp@puck.nether.net
https://puck.nether.net/mailman/listinfo/juniper-nsp
