Hi all , the issue is that upload traffic is load balanced but the download is not The traffic passing through the aggregate is Layer 4 traffic I have configured hashing on Layer 3 and Layer 4 from the mx480 side on the ex4200 side am getting prompted that the hashing is not supported , does anyone know if there is a specific image on the EX4200 that supports hashing ? Your input is highly appreciated
On Tue, Nov 13, 2012 at 5:08 PM, Mohammad Khalil <eng.m...@gmail.com> wrote: > Hi all > AM still facing the same issue , one of the links are fully utilized and > the other one has free space to utilize > I have configured the below > set forwarding-options hash-key family mpls label-1 > set forwarding-options hash-key family mpls label-2 > set forwarding-options hash-key family mpls payload ip > set forwarding-options hash-key family inet layer-3 > set forwarding-options hash-key family inet layer-4 > > But the downstream traffic is not balanced , even though the upload > traffic is almost balanced > > Any ideas? > > BR, > Mohammad > > > > > On Sat, Jul 21, 2012 at 2:09 AM, Mohammad Khalil <eng.m...@gmail.com>wrote: > >> I am running MPLS in my network , L3 and VPLS >> >> >> On Thu, Jul 19, 2012 at 10:03 PM, Doan Nguyen <doan_gr...@yahoo.com>wrote: >> >>> Take off the MTU setting and leave it default. Are you running any >>> thing bigger than 1500 with DF bit set? >>> >>> ------------------------------ >>> *From:* Mohammad Khalil <eng.m...@gmail.com> >>> *To:* juniper-nsp@puck.nether.net >>> *Sent:* Thursday, July 19, 2012 1:48 AM >>> *Subject:* [j-nsp] Fwd: mx480 to mx240 port channel ae >>> >>> ---------- Forwarded message ---------- >>> From: Mohammad Khalil <eng.m...@gmail.com> >>> Date: Wed, Jul 18, 2012 at 11:45 AM >>> Subject: mx480 to mx240 port channel ae >>> To: juniper-nsp@puck.nether.net >>> >>> >>> Hi all , I have mx480 and mx240 routers >>> I tried to connect them via ether channel (port aggregation) , but there >>> was remarkable packet loss >>> >>> CR04# show interfaces ae1 >>> flexible-vlan-tagging; >>> mtu 1600; >>> encapsulation flexible-ethernet-services; >>> aggregated-ether-options { >>> lacp { >>> active; >>> } >>> } >>> unit 0 { >>> family bridge { >>> interface-mode trunk; >>> } >>> } >>> unit 10 { >>> vlan-id 10; >>> family inet { >>> address 10.0.0.17/30; >>> >>> Any ideas ? >>> >>> Thanks >>> >>> BR, >>> Mohammad >>> _______________________________________________ >>> juniper-nsp mailing list juniper-nsp@puck.nether.net >>> https://puck.nether.net/mailman/listinfo/juniper-nsp >>> >>> >>> >> > _______________________________________________ juniper-nsp mailing list juniper-nsp@puck.nether.net https://puck.nether.net/mailman/listinfo/juniper-nsp