Hi Charles,Thanks for your reply.As I explained in my previous e-mail, Cisco router that run BGP deals with its neighbor as two groups by defaults, one for external peers with 30 seconds as Minimum time between advertisement and 0 second for internal peers.this an example of the output of the command show ip bgp update-group : BGP version 4 update-group 1, external, Address Family: IPv4 Unicast BGP Update version : 30/0, messages 0, active RGs: 1 Topology: global, highest version: 30, tail marker: 30 Format state: Current working (OK, last minimum advertisement interval) Refresh blocked (not in list, last not in list) Update messages formatted 27, replicated 54, current 0, refresh 0, limit 1000 Number of NLRIs in the update sent: max 1, min 0 Minimum time between advertisement runs is 30 seconds Has 2 members: 10.0.0.25 10.0.0.30 What I need is simply output of an equivalent command in Juniper router or how is the behavior of BGP with Juniper router.
Regards Bahaa From: Charles van Niman <char...@phukish.com> To: Eng. Bahaa <baha...@yahoo.com> Cc: "juniper-nsp@puck.nether.net" <juniper-nsp@puck.nether.net> Sent: Wednesday, June 3, 2015 11:04 PM Subject: Re: [j-nsp] BGP behaviour with Juniper router Hello, Not quite sure what you mean by groups, I usually just refer to them in cisco-land as "types, ibgp/ebgp" until I'm actually using the peer-group neighbor statements. As for the command, you might try show route receive-protocol bgp <neighbor>. This is a pretty good reference: http://networking.ringofsaturn.com/Cisco/ciscojuniper.php and Juniper has some pretty good documentation as well. /Charles On Wed, Jun 3, 2015 at 7:39 AM, Eng. Bahaa via juniper-nsp <juniper-nsp@puck.nether.net> wrote: > Hi Guys,I am new with this group and with Juniper products as well.I curious > to know the behaviour of BGP routing with Juniper routers.With Cisco router, > a BGP speaker deals by default with all external peers as one group and with > internal peers as another group.With external peers,it starts a timer of 30 > seconds after each announce or forwarded update/updates to other neighbors > while it send it directly with 0 seconds to internal peers (on the same > AS).My question is Juniper routers work in the same behaviour?I really > appreciate if someone has configured BGP in Juniper router and send me the > o/p of show ip bgp update-groups (this a cisco command not really sure how it > looks like in Juniper). > > Regards > Bahaa > > > _______________________________________________ > juniper-nsp mailing list juniper-nsp@puck.nether.net > https://puck.nether.net/mailman/listinfo/juniper-nsp _______________________________________________ juniper-nsp mailing list juniper-nsp@puck.nether.net https://puck.nether.net/mailman/listinfo/juniper-nsp