Cisco and iOS xr has been good for me... Show cef (vrf xyz) ..... Isn't Junos equivalent for showing FIB/PFE "show route forwarding...." ? This usually is good for me too
Aaron > On May 14, 2018, at 6:35 PM, Nikolas Geyer <n...@neko.id.au> wrote: > > The platforms I have used it on it has been correct, but that doesn’t include > ASR9k. > > Scary to think what you have said could happen, but I guess I shouldn’t be > surprised. > > Sent from my iPhone > >> On 14 May 2018, at 7:32 pm, Saku Ytti <s...@ytti.fi> wrote: >> >> Have you found cef exact-route to be correct? >> >> Last time I used this (ASR9000), it was giving wrong results to me. I >> think there is entirely separate piece of code for LAG result in >> software code and the CSCO EZChip microcode, and different people code >> IOS-XR than ezchip, so I think there is failure mode where one code is >> updated, and another is not, I hope I'm wrong. >> >> But if I'm right, then the only way to do this, is actually ask the >> microcode 'hey i have this packet, do a lookup for it', or like in >> CAT7600/ELAM, get lookup results for real traffic. >> >>> On 15 May 2018 at 02:27, Nikolas Geyer <n...@neko.id.au> wrote: >>> Unless it’s changed in newer releases there is no equivalent which is >>> annoying. >>> >>> I believe you can drop to the FPC vty and extract the information card by >>> card similar to the link you shared, but it’s not exactly a workable >>> solution, nor “officially supported” by Juniper. >>> >>> The lack of this command is literally my biggest frustration with Juniper. >>> >>> Sent from my iPhone >>> >>>> On 11 May 2018, at 4:40 am, James Bensley <jwbens...@gmail.com> wrote: >>>> >>>> Hi All, >>>> >>>> Does anyone know of a command like the Cisco CEF "exact-route" command >>>> on Juniper? >>>> >>>> I've seen this older thread: https://lists.gt.net/nsp/juniper/50645 >>>> >>>> Which links to a post on using JSIM but for DPC cards, but I'm >>>> interested in MPC cards: >>>> http://junosandme.net/article-junos-load-balancing-part-3-troubleshooting-109382234.html >>>> >>>> Does anyone have any details on using JSIM on MPC cards on MX >>>> platforms? Or is there "another way" ? >>>> >>>> I'm going to open a JTAC case as well as asking here however, in the >>>> past they have rejected requests to explain PFE commands to me or >>>> provide documentation for them. I have managed it a few times but only >>>> after a couple of weeks of non-stop screaming. So I'm not holding my >>>> breath for that option. >>>> >>>> Kind regards, >>>> James. >>>> _______________________________________________ >>>> juniper-nsp mailing list juniper-nsp@puck.nether.net >>>> https://puck.nether.net/mailman/listinfo/juniper-nsp >>> _______________________________________________ >>> juniper-nsp mailing list juniper-nsp@puck.nether.net >>> https://puck.nether.net/mailman/listinfo/juniper-nsp >> >> >> >> -- >> ++ytti > _______________________________________________ > juniper-nsp mailing list juniper-nsp@puck.nether.net > https://puck.nether.net/mailman/listinfo/juniper-nsp _______________________________________________ juniper-nsp mailing list juniper-nsp@puck.nether.net https://puck.nether.net/mailman/listinfo/juniper-nsp