I could add this too. On Sun, Jun 07, 2015 at 05:44:09PM -0400, Wayne Stambaugh wrote: > One thing I did notice is that bus entries do not draw the connection > point so they cannot show their connection status. It would be nice if > bus entries exhibited the same behavior. I'm not sure how much work > would be involved. I'm surprised I never noticed that before or AFAIR > no one has every said anything about it. > > On 6/4/2015 6:21 PM, Chris Pavlina wrote: > > Recently a proposal was made on Launchpad for pins to indicate when they > > are connected: https://bugs.launchpad.net/kicad/+bug/1458083 > > > > Sounds like a good idea to me; I recently asked on the list, and on both > > list and Launchpad there is general agreement that the second proposal > > (hide the pin target after the connection is made) was best. Here's a > > patch to do this. > > > > IMO it makes the schematic look a lot cleaner in addition to helping > > make sure the schematic is connected correctly :) > > > > -- > > Chris > > > > > > > > _______________________________________________ > > Mailing list: https://launchpad.net/~kicad-developers > > Post to : kicad-developers@lists.launchpad.net > > Unsubscribe : https://launchpad.net/~kicad-developers > > More help : https://help.launchpad.net/ListHelp > > > > > _______________________________________________ > Mailing list: https://launchpad.net/~kicad-developers > Post to : kicad-developers@lists.launchpad.net > Unsubscribe : https://launchpad.net/~kicad-developers > More help : https://help.launchpad.net/ListHelp
_______________________________________________ Mailing list: https://launchpad.net/~kicad-developers Post to : kicad-developers@lists.launchpad.net Unsubscribe : https://launchpad.net/~kicad-developers More help : https://help.launchpad.net/ListHelp