I built my entire boat section and spars from Doug fir. At the time, our
shop was ordering some very high quality lumber for our trusses. so I would
take my breaks and lunch look through every new unit that was opened. After
about three months I was able to find quite a bit and then "acclimated it"
to our conditions for 8 months before I even attempted to mill it for my
airplane. our summer humidity can be 8% or less and even though it was "DRY"
lumber it's moisture was always in the 19-20% range.



The whole boat was 28# including the vertical tail spar. No ply of course.



Spruce is a little more forgiving, doesn't splinter as easily, but doug fir,
white cedar, Alaskan yellow cedar, even hem fir (sometimes called piss fir
for obvious reasons) works well, depending on what part of the country you
live in of course.



Just research the web about it first, there is lots of info about the
airworthiness of certain lumber.







Fred Johnson

Reno, NV





David wrote:



I was wondering if there was anyone that has used other woods for aviation
projects instead of spruce. Spruce is getting hard to obtain at reasonable
prices and there are other woods that are stronger, but a little heavier. I
am looking at a larger engine so I think the weight issue could be balanced
off.

Any help would be appreciated.

David Stowers
_______________________________________


Reply via email to