> I'm about ready to close up my aluminum wing fuel tanks and need some
advice on the pick up and vent. These tanks are very similar to those on
Mark Jones' website. 
> 1: I'm thinking of eliminating the pick up tube and installing the AN
fitting, with a finger screen attached, right near the bottom of the tank. I
think this setup would prevent the possibility of a loose pick up tube
falling off inside the tank.
> 2: I'm installing the filler/ cap toward the wing tip end of the tank.
What are your thought of a simple 1/4" tube attached on the filler neck
pointing toward the airstream above the wing like the header tank design in
the KR plans? Or should I attach the tube to the filler neck and route it
out the bottom of the wing? Which would perform better? Pro and cons?
> Your thoughts and ideas are welcomed. 
> 
> Rodger Nicolls 
> [email protected]
> 
> Blue skies!


 I would install the vent line into the lower skin, extend it through the 
underside pointing downward. Cut a 50deg. angle in the tube on the foreword
face to give you positive air flow. I did this on my composite tank,
extending the vent tube through the firewall and downward with that angle. I
didn't want a ram air effect that pressurizes the tank with increased
airspeed speed. Also I attached a little screen to the bottom of the vent.

Joe

Valley View, Ore.


Reply via email to