Joe,
Thank you. That's kinda what I was thinking for the vent. 

Rodger


On Nov 17, 2011, at 8:37 PM, "Joe Beyer" <[email protected]> wrote:

> 
>> I'm about ready to close up my aluminum wing fuel tanks and need some
> advice on the pick up and vent. These tanks are very similar to those on
> Mark Jones' website. 
>> 1: I'm thinking of eliminating the pick up tube and installing the AN
> fitting, with a finger screen attached, right near the bottom of the tank. I
> think this setup would prevent the possibility of a loose pick up tube
> falling off inside the tank.
>> 2: I'm installing the filler/ cap toward the wing tip end of the tank.
> What are your thought of a simple 1/4" tube attached on the filler neck
> pointing toward the airstream above the wing like the header tank design in
> the KR plans? Or should I attach the tube to the filler neck and route it
> out the bottom of the wing? Which would perform better? Pro and cons?
>> Your thoughts and ideas are welcomed. 
>> 
>> Rodger Nicolls 
>> [email protected]
>> 
>> Blue skies!
> 
> 
> I would install the vent line into the lower skin, extend it through the 
> underside pointing downward. Cut a 50deg. angle in the tube on the foreword
> face to give you positive air flow. I did this on my composite tank,
> extending the vent tube through the firewall and downward with that angle. I
> didn't want a ram air effect that pressurizes the tank with increased
> airspeed speed. Also I attached a little screen to the bottom of the vent.
> 
> Joe
> 
> Valley View, Ore.
> 
> 
> 
> _______________________________________
> Search the KRnet Archives at http://www.maddyhome.com/krsrch/index.jsp
> to UNsubscribe from KRnet, send a message to [email protected]
> please see other KRnet info at http://www.krnet.org/info.html

Reply via email to