On Mon, Apr 01, 2013 at 05:47:48PM -0500, Scott Wood wrote:
> Currently, devices that are emulated inside KVM are configured in a
> hardcoded manner based on an assumption that any given architecture
> only has one way to do it. If there's any need to access device state,
> it is done through inflexible one-purpose-only IOCTLs (e.g.
> KVM_GET/SET_LAPIC). Defining new IOCTLs for every little thing is
> cumbersome and depletes a limited numberspace.
>
> This API provides a mechanism to instantiate a device of a certain
> type, returning an ID that can be used to set/get attributes of the
> device. Attributes may include configuration parameters (e.g.
> register base address), device state, operational commands, etc. It
> is similar to the ONE_REG API, except that it acts on devices rather
> than vcpus.
>
> Both device types and individual attributes can be tested without having
> to create the device or get/set the attribute, without the need for
> separately managing enumerated capabilities.
>
> Signed-off-by: Scott Wood <scottw...@freescale.com>
Some comments below...
> diff --git a/Documentation/virtual/kvm/api.txt
> b/Documentation/virtual/kvm/api.txt
> index 976eb65..77328aa 100644
> --- a/Documentation/virtual/kvm/api.txt
> +++ b/Documentation/virtual/kvm/api.txt
> @@ -2173,6 +2173,76 @@ header; first `n_valid' valid entries with contents
> from the data
> written, then `n_invalid' invalid entries, invalidating any previously
> valid entries found.
>
> +4.79 KVM_CREATE_DEVICE
> +
> +Capability: KVM_CAP_DEVICE_CTRL
I notice this patch doesn't add this capability; you add it in a later
patch. Since this patch adds the KVM_CREATE_DEVICE ioctl, it probably
should add the KVM_CAP_DEVICE_CTRL capability too.
> +Type: vm ioctl
> +Parameters: struct kvm_create_device (in/out)
> +Returns: 0 on success, -1 on error
> +Errors:
> + ENODEV: The device type is unknown or unsupported
> + EEXIST: Device already created, and this type of device may not
> + be instantiated multiple times
> + ENOSPC: Too many devices have been created
Is this still a possible error code?
> --- a/arch/powerpc/include/asm/kvm_host.h
> +++ b/arch/powerpc/include/asm/kvm_host.h
> @@ -370,6 +370,9 @@ struct kvmppc_booke_debug_reg {
> u64 dac[KVMPPC_BOOKE_MAX_DAC];
> };
>
> +#define KVMPPC_IRQCHIP_NONE 0
> +#define KVMPPC_IRQCHIP_MPIC 1
This define should go in the patch that adds the MPIC device.
> struct kvm_vcpu_arch {
> ulong host_stack;
> u32 host_pid;
> @@ -549,6 +552,9 @@ struct kvm_vcpu_arch {
> unsigned long magic_page_pa; /* phys addr to map the magic page to */
> unsigned long magic_page_ea; /* effect. addr to map the magic page to */
>
> + int irqchip_type;
> + void *irqchip_priv;
Since you add this (irqchip_priv) only to remove it in a later patch
and replace it by a device-specific pointer, why bother adding it
here? And why not give irqchip_type the name it ultimately ends up
with?
> diff --git a/arch/powerpc/kvm/powerpc.c b/arch/powerpc/kvm/powerpc.c
> index 16b4595..bdfa526 100644
> --- a/arch/powerpc/kvm/powerpc.c
> +++ b/arch/powerpc/kvm/powerpc.c
> @@ -459,6 +459,13 @@ void kvm_arch_vcpu_free(struct kvm_vcpu *vcpu)
> tasklet_kill(&vcpu->arch.tasklet);
>
> kvmppc_remove_vcpu_debugfs(vcpu);
> +
> + switch (vcpu->arch.irqchip_type) {
> + case KVMPPC_IRQCHIP_MPIC:
> + mpic_put(vcpu->arch.irqchip_priv);
> + break;
> + }
This is going to break bisection, since you don't define mpic_put() in
this patch.
> diff --git a/include/uapi/linux/kvm.h b/include/uapi/linux/kvm.h
> index 74d0ff3..20ce2d2 100644
> --- a/include/uapi/linux/kvm.h
> +++ b/include/uapi/linux/kvm.h
> @@ -668,6 +668,7 @@ struct kvm_ppc_smmu_info {
> #define KVM_CAP_PPC_EPR 86
> #define KVM_CAP_ARM_PSCI 87
> #define KVM_CAP_ARM_SET_DEVICE_ADDR 88
> +#define KVM_CAP_DEVICE_CTRL 89
>
> #ifdef KVM_CAP_IRQ_ROUTING
>
> @@ -909,6 +910,32 @@ struct kvm_s390_ucas_mapping {
> #define KVM_ARM_SET_DEVICE_ADDR _IOW(KVMIO, 0xab, struct
> kvm_arm_device_addr)
>
> /*
> + * Device control API, available with KVM_CAP_DEVICE_CTRL
> + */
> +#define KVM_CREATE_DEVICE_TEST 1
> +
> +struct kvm_create_device {
> + __u32 type; /* in: KVM_DEV_TYPE_xxx */
> + __u32 fd; /* out: device handle */
> + __u32 flags; /* in: KVM_CREATE_DEVICE_xxx */
> +};
> +
> +struct kvm_device_attr {
> + __u32 flags; /* no flags currently defined */
> + __u32 group; /* device-defined */
> + __u64 attr; /* group-defined */
> + __u64 addr; /* userspace address of attr data */
> +};
> +
> +/* ioctl for vm fd */
> +#define KVM_CREATE_DEVICE _IOWR(KVMIO, 0xe0, struct kvm_create_device)
This define should go with the other VM ioctls, otherwise the next
person to add a VM ioctl will probably miss it and reuse the 0xe0
code.
Paul.
--
To unsubscribe from this list: send the line "unsubscribe kvm-ppc" in
the body of a message to majord...@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
