Am 22.02.23 um 18:01 schrieb Bo Berglund via lazarus:
On Wed, 22 Feb 2023 10:43:35 +0100, Bo Berglund via lazarus
<[email protected]> wrote:
Lacking any advice here I started over by removing the old Lazarus directory and
the pcp dir and then build from start with a new set of source files in a fresh
2.2.4 subdir...
All was Ok until again the OLPM packages were installed when the new Lazarus
also failed to start. It seems like at least one of the packages I use from OLPM
will hose Lazarus!
So now I will repeat the effort but this time I will install one package after
another using OLPM and rebuild Lazarus IDE after each. This way I would be able
to pinpoint the one that causes the problem.
So now I have found a package in OnLinePackageManager that will hose Lazarus if
installed:
BGRABitmap
*I could install this package on my:*
*Lazarus 2.3.0 (rev main-2_3-2873-g17b66f88c4) FPC 3.2.2 x86_64-linux-gtk2*
*Linux manjaro 6.1.12-1-MANJARO #1 SMP PREEMPT_DYNAMIC Tue Feb 14
21:59:10 UTC 2023 x86_64 GNU/Linux
*
*
*
*Perhaps start lazarus from terminal to see what its telling ?!*
Up until installing that I was fine, but now Lazarus won't start....
The Initial image is shown for 3 seconds and then disappears.
Then nothing...
What can I do to get into Lazarus and remove the BGRABitmap?
Or is there somewhere a file or such I can edit and then rebuild the IDE from
the command line?
This is on Linux (Raspberry Pi OS).
--
_______________________________________________
lazarus mailing list
[email protected]
https://lists.lazarus-ide.org/listinfo/lazarus
