I am presently running eigerstien2beta 3.1.0 as a ppp dialup with no
problems. However in about a week I will have DSL using PPPoA. The modem
will have an ethernet port with an IP of 192.168.1.1 and the connecting
system, LRP box, IP has to be 192.168.1.2. My internal network will be
192.168.2.x. Ok, I posted about the ipmasqing of private network
addresses and Jeff Newmiller was kind enough to point me to the FAQ
concerning this. Thanks again Jeff.
Ok, now that is understood I was looking at how to changes my Eigerstien
from ppp on the internet side to ethernet. I am a Slackware person and I
know how to do it in the /etc/rc.d/rc.inet1 script, no problem. But, in
looking over the leaf network.conf file I got confused on how to change
it this way.
Could somebody point me in the right direction on to set up the
following:
eth0 to internet (i.e. DSL modem) IP=192.168.1.2 gateway=192.168.1.1
(address of modem), no DHCP
My first plan is to use my main Linux box to act as the modem with ppp
and it's ethernet being 192.168.1.1 and connect it to eth0 of the
router. This way my main system simulates the modem and I can debug the
router settings. So when the install happens all I should have to do is
plug in the modem, boot the pre-tested DSL disk and go 10 times faster,
512Kb downsteam.
--
Jeff Pierce
[EMAIL PROTECTED]
http://pages.preferred.com/~piercej
_______________________________________________
Leaf-user mailing list
[EMAIL PROTECTED]
http://lists.sourceforge.net/lists/listinfo/leaf-user
