Paul M. Wright, Jr. wrote: [...] > The card on the internal network works fine, but the card on the cable > modem > side just will not get a DHCP address. I receive a couple of console > messages: > > ETH0: Receive set to 1 addresses > ETH0: Receive set to 0 addresses > ETH0: Receive set to 1 addresses > Operation failed > > Then the boot continues but 'ifconfig -v eth0' show no IP address. > > Is there something peculiar about these cards and dhclient?
Can't help with the error messages, never seen them. I don't know about Bering but the 3c509's work fine with dhclient and Dachstein. I've a cable setup here and they've worked flawlessly under various configs. If your internal network cabling is different to the ext. you may need to configure the card to use the correct interface (10base2 or 10 baseT) To do this you'll need the config program 3c5x9cfg.exe , run under dos. I've seen the file on leaf.sourceforge somewhere but a quick google should find one --- that's if it *is* you're problem :-) HTH -- Cheers Glenn http://members.optushome.com.au/graybeard/linux/netboot.html _______________________________________________ Leaf-user mailing list [EMAIL PROTECTED] https://lists.sourceforge.net/lists/listinfo/leaf-user
