I am trying to create a bering floppy setup for my firewall and I am having trouble I think with the nics being recognized. I am using a smz ez100 nic and I tried using the tulip driver module and I also tried the 8139 module because it works in my smoothwall, I also had installed a intel pro100+ and took out a intel etherexpress16 because I wanted full duplex, I did not find a module for the intel pro100, intel supplies uncompiled code for one called e100.c but I am not set up to compile. I could not figure out which nic was not being recognized but I did get a message line saying "eth1 does not exist" I could not figure out which nic was eth0 and 1 and what address they had, I tried ifup and ifdown but I am not very familiar with most linux commands. I tried a few different modules but could not get it working. smoothwall also did not recognise the intel pro100+ but smoothwall is using ipchains and I wanted the capabilies found in bering (iptables etc.).
does anyone have any ideas for me to figure out what nics are working and what are not? thanks, Tiger ------------------------------------------------------- This sf.net email is sponsored by:ThinkGeek Welcome to geek heaven. http://thinkgeek.com/sf ------------------------------------------------------------------------ leaf-user mailing list: [EMAIL PROTECTED] https://lists.sourceforge.net/lists/listinfo/leaf-user SR FAQ: http://leaf-project.org/pub/doc/docmanager/docid_1891.html
