I am using three 3com 905 Boomerang nics and am trying to run Bearing 1.0-rc3. During start-up the cards are detected, however, later in the start-up, the interface configuration fails. In looking at the nics themselves, when a cable modem in plugged into eth0 (setup as net) it lights up and shows an active connection. I also plugged a laptop into eth1 (setup as loc) and the nic did not show an active connection. To check to see if the nic was bad I swapped the cards between eth0 and eth1 with the same results. I then tired switching the connections hooking eth0 to the laptop and eth1 to the cable modem. This time eth1 showed a connection and eth0 did not. I have edited /etc/modules so that it loads the 3c59x.o as the driver and double checked the configuration files against the install guide and user manuals. In reading FAQ sec3, "How do I make Leaf see my Ethernet Cards," it makes mention of the 3com modules being dependent on a module called pci-scan.o. However, I have been unable to find a place to download it. At this point, I'm not sure that this is actually a driver problem but I can figure out what else it could be. I can find no information in the log files. But, it's also possible I am looking in the wrong place. Any help you can provide would be greatly appreciated... -Wil
------------------------------------------------------- This sf.net email is sponsored by: OSDN - Tired of that same old cell phone? Get a new here for FREE! https://www.inphonic.com/r.asp?r=sourceforge1&refcode1=vs3390 ------------------------------------------------------------------------ leaf-user mailing list: [EMAIL PROTECTED] https://lists.sourceforge.net/lists/listinfo/leaf-user SR FAQ: http://leaf-project.org/pub/doc/docmanager/docid_1891.html
