It seems that your floppy must have been almost full when you ran the backup, ending up with a corrupted vlan.lrp...
I guess you must redo the config again. -----Original Message----- From: Scott [mailto:leaf@;troutpocket.org] Sent: Tuesday, November 12, 2002 7:27 AM To: [EMAIL PROTECTED] Subject: [leaf-user] restoring vlan's after reboot: /proc/net/vlan not there using Intel Pro/100 82559 chipset using eepro100 Revision 1.36 using bering rc4 On boot I'm getting the error: SIOCGIFFLAGS: Operation not supported by device I load the 802.1q driver (8021q.o). I configure my vlan with the following command lines: vconfig add eth1 11 vconfig add eth2 12 vconfig add eth3 13 etc... I backup the vlan. When I reboot, it is not finding the devices eth1.11, eth1.12, and eth1.13. I check /proc/net/vlan and it's empty where there used to be entries for each virtual device. /var/lib/lrpkg/vlan.list: sbin/vconfig etc/network/if-pre-up.d/vlan etc/network/ip-up.d/ip etc/network/if-post-down.d/vlan var/lib/lrpkg/vlan.* By default there is no entry in vlan.list for /proc/net/vlan. I tried adding it, but it bombs when I try "lrpkg -i vlan" later with a tar error. Any suggestions how to have those vlans active when I boot? Otherwise shorewall doesn't have anything to configure. -Scott ------------------------------------------------------- This sf.net email is sponsored by:ThinkGeek Welcome to geek heaven. http://thinkgeek.com/sf ------------------------------------------------------------------------ leaf-user mailing list: [EMAIL PROTECTED] https://lists.sourceforge.net/lists/listinfo/leaf-user SR FAQ: http://leaf-project.org/pub/doc/docmanager/docid_1891.html ------------------------------------------------------- This sf.net email is sponsored by:ThinkGeek Welcome to geek heaven. http://thinkgeek.com/sf ------------------------------------------------------------------------ leaf-user mailing list: [EMAIL PROTECTED] https://lists.sourceforge.net/lists/listinfo/leaf-user SR FAQ: http://leaf-project.org/pub/doc/docmanager/docid_1891.html