-----BEGIN PGP SIGNED MESSAGE----- Hash: SHA1 Vanja Milosevski wrote: > I found the old diskette by the NIC manufacturer and they say, in the > manual, that for Linux the tulip module is required. Good news, thix fixes the trouble on 'which module is needed'
> However, it is not included by default in the Bering-uClibs in /lib/modules. Try to download modules, then put the module on the disk and test it using insmod, only to be sure that it works. Giovanni > > How do I go about adding it? > > > > > > > > On Sun, Jul 13, 2008 at 5:12 PM, Giovanni Franza <[EMAIL PROTECTED]> wrote: > Vanja Milosevski wrote: >>>> What's the exact procedure of installing these modules in the >>>> configuration wizard? > editing the file modules using the menu, then save all from menu, then > reboot the firewall > >>>> As I did uncommented those in the conf file, however when I check >>>> lsmod once I restarted the machine they do not appear in the list. >>>> > have you saved the configuration ? pay attention: not the single file, > it is in RAM, but the configuration, from the menu. > >>>> Also, does it make much difference whether they are started at the >>>> beginning of the boot procedure or the end? > At the beginning, before the startup of shorewall. > >>>> Because after I booted the >>>> system I tried loading them with insmod individually one-by-one but >>>> they cannot seem to recognize the card and when I type lsmod I get >>>> "unused" to appear infront of the activated modules. > this is interesting: using insmod to install mii, crc32 and 8139too has > no results ? > try to insmod these modules and then do /etc/init.d/network start to see > what happens ... > > HTH > > Giovanni > >>>> >>>> >>>> >>>> On Sat, Jul 12, 2008 at 1:19 PM, Giovanni Franza <[EMAIL PROTECTED]> wrote: >>>> Vanja Milosevski wrote: >>>>>>> Hello, >>>>>>> >>>>>>> I'm trying to configure a network card to work on LEAF Bering-uClibc >>>>>>> latest. >>>>>>> >>>>>>> Windows (which I have installed on the same box) reports that this is >>>>>>> a TENDA TEL8139 10/100 network card. >>>>>>> >>>> try 8139too (plus mii and crc32 or something similar - 8139too depends >>>> on them - if I remember correctly) >>>> >>>>>>> I'm not sure which modules should I enable? >>>>>>> Furthermore, how do I go about verifying whether everything is OK, >>>>>>> since ifconfig is missing? >>>> ip addr and, generally speaking, command "ip" that is part of iproute >>>> debian package (and of the leaf base system) >>>> >>>>>>> I tried configuring it myself, but without any success. >>>>>>> >>>> to configure see /etc/network/interfaces: it si similar to debian. >>>> You must use the menus that start when you log on as root, after >>>> installation. >>>> >>>>>>> Thanks. >>>>>>> >>>> Hope this helps >>>> >>>> Giovanni >>>> >>>> >>>>>>> ------------------------------------------------------------------------- >>>>>>> Sponsored by: SourceForge.net Community Choice Awards: VOTE NOW! >>>>>>> Studies have shown that voting for your favorite open source project, >>>>>>> along with a healthy diet, reduces your potential for chronic lameness >>>>>>> and boredom. Vote Now at http://www.sourceforge.net/community/cca08 >>>>>>> ------------------------------------------------------------------------ >>>>>>> leaf-user mailing list: leaf-user@lists.sourceforge.net >>>>>>> https://lists.sourceforge.net/lists/listinfo/leaf-user >>>>>>> Support Request -- http://leaf-project.org/ >>>>>>> >>>>>>> >>>> ------------------------------------------------------------------------- >>>> Sponsored by: SourceForge.net Community Choice Awards: VOTE NOW! >>>> Studies have shown that voting for your favorite open source project, >>>> along with a healthy diet, reduces your potential for chronic lameness >>>> and boredom. Vote Now at http://www.sourceforge.net/community/cca08 >>>> ------------------------------------------------------------------------ >>>> leaf-user mailing list: leaf-user@lists.sourceforge.net >>>> https://lists.sourceforge.net/lists/listinfo/leaf-user >>>> Support Request -- http://leaf-project.org/ > > >> -----BEGIN PGP SIGNATURE----- Version: GnuPG v1.4.6 (GNU/Linux) Comment: Using GnuPG with Mozilla - http://enigmail.mozdev.org iD8DBQFIe5UH4yUxzYWi6QcRAjFkAJkBtgZMp8tRoBJpBAJRbOBMJC+WDQCfWTLY 8ghW9SPLu1zRwrwIIUoaLt0= =IGjw -----END PGP SIGNATURE----- ------------------------------------------------------------------------- Sponsored by: SourceForge.net Community Choice Awards: VOTE NOW! Studies have shown that voting for your favorite open source project, along with a healthy diet, reduces your potential for chronic lameness and boredom. Vote Now at http://www.sourceforge.net/community/cca08 ------------------------------------------------------------------------ leaf-user mailing list: leaf-user@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/leaf-user Support Request -- http://leaf-project.org/