You could double thick the 3/4" MDF just in the area between the rails. That would allow enough material to insertt the clamps into a sufficiently deep hole while still having the MDF's top surface at the usual level. The extra MDF glued on the bottom might even make the structure more rigid.
_____ From: legacy-ornamental-mills@googlegroups.com [mailto:legacy-ornamental-mills@googlegroups.com] On Behalf Of Tim Krause Sent: Tuesday, January 18, 2011 5:30 PM To: legacy-ornamental-mills@googlegroups.com Subject: Re: clamps You would loose some table capacity because the cam clamps take over an inch of material to mount in. They are pretty low profile. -Tim ----- Original Message ----- From: Bill <mailto:bulke...@mmnet.com.au> Bulkeley To: legacy-ornamental-mills@googlegroups.com Sent: Monday, January 17, 2011 4:35 PM Subject: clamps I was surfing the net last night and came across these might be useful on the legacy what do you guys think I'm not sure if any one has found these before or not but have another look and tell me what you all think http://www.veritastools.com/Products/Page.aspx?p=512 Bill -- You received this message because you are subscribed to the Google Groups "Legacy Ornamental Mills" group. To post to this group, send email to legacy-ornamental-mills@googlegroups.com. To unsubscribe from this group, send email to legacy-ornamental-mills+unsubscr...@googlegroups.com. For more options, visit this group at http://groups.google.com/group/legacy-ornamental-mills?hl=en. -- You received this message because you are subscribed to the Google Groups "Legacy Ornamental Mills" group. To post to this group, send email to legacy-ornamental-mills@googlegroups.com. To unsubscribe from this group, send email to legacy-ornamental-mills+unsubscr...@googlegroups.com. For more options, visit this group at http://groups.google.com/group/legacy-ornamental-mills?hl=en. -- You received this message because you are subscribed to the Google Groups "Legacy Ornamental Mills" group. To post to this group, send email to legacy-ornamental-mills@googlegroups.com. To unsubscribe from this group, send email to legacy-ornamental-mills+unsubscr...@googlegroups.com. For more options, visit this group at http://groups.google.com/group/legacy-ornamental-mills?hl=en.