looks good what is the size and rpm of the motor\
Bill
Quoting curt george <curtgeo...@wowway.com>:
BOB
Im in a hurry so I need to make this quick, You realy need a 90volt
DC motor small on will not work well for long.
here are some of the motors set ups that I've done on my machine.
Good luck!
The motor is the only way to go, If you ask me.
C.A.G.
----- Original Message ----- From: "BOB" <bandlels...@cqservices.com>
To: "Legacy Ornamental Mills" <legacy-ornamental-mills@googlegroups.com>
Sent: Thursday, February 03, 2011 1:29 AM
Subject: linear drive
this might not be a popular idea but i thought I'd give it a try been
thinking about it, has any one considered going low tech with a linear
drive system a dc motor like a wiper or power window motor both have
gear reduction you could use the same control switch hooked to a foot
pedal have no limit switches and have the motor coupled to the lead
screw using a sprag or roller clutch so that when you got close to the
end you would turn it off and finish by hand the down side would be
you would have to loosen the split not to back it up. using the clutch
setup it would remove easily for times that you would not want it i
have been making balusters for a while now and my shoulders are
telling me that i should look for another way bob
--
You received this message because you are subscribed to the Google
Groups "Legacy Ornamental Mills" group.
To post to this group, send email to
legacy-ornamental-mills@googlegroups.com.
To unsubscribe from this group, send email to
legacy-ornamental-mills+unsubscr...@googlegroups.com.
For more options, visit this group at
http://groups.google.com/group/legacy-ornamental-mills?hl=en.
--
You received this message because you are subscribed to the Google
Groups "Legacy Ornamental Mills" group.
To post to this group, send email to
legacy-ornamental-mills@googlegroups.com.
To unsubscribe from this group, send email to
legacy-ornamental-mills+unsubscr...@googlegroups.com.
For more options, visit this group at
http://groups.google.com/group/legacy-ornamental-mills?hl=en.
--
You received this message because you are subscribed to the Google Groups "Legacy
Ornamental Mills" group.
To post to this group, send email to legacy-ornamental-mills@googlegroups.com.
To unsubscribe from this group, send email to
legacy-ornamental-mills+unsubscr...@googlegroups.com.
For more options, visit this group at
http://groups.google.com/group/legacy-ornamental-mills?hl=en.
