a great motor too if you can get one for our legacy's is a shop sliding door motor you know those electric doors on every shop and supermarket now I was going into a shop a few days ago and one was apart being repaired and I was talking to the repair man its a 12volt dc motor geared slow and lots of grunt I bet it work really well on our machines provided you can get one of corse
Bill ----- Original Message ----- From: curt george To: Legacy Google group Sent: Thursday, December 08, 2011 12:03 PM Subject: I made a new toy today. Hello Everyone. Today I finely finished my spindle motor drive unit.And I did it somewhat differently than what everyone else has already done. instead of hooking up the spindle drive into the head stock, I used the tail stock side instead. My reasons were many for doing it this way, "but in a nut shell" the biggest reason I did what I did was, I just could not get the materials to make the motor and the trencher gears,work on every position the Legacy could be moved to. So instead of going through the front door, I went through the back door instead. ;-) The motor is a 12 volt DC wheel chair motor. I used a 2 1/2" riser clamp to hold the motor, two 5/16"x4" carriage bolts and some knobs to adjust the motor onto the Legacy tail stock. The gears and the chain are form an Audi timing system (car parts) the tail stock live center is a $20.00 jet live center (on sale at Rockler) All that I had to do was to boar out the gear to mate up to the live center, then cut and wield the drive gear hub onto the live center. and it was done! ;-) "O" I did have to take apart the chain and shorten it a bit as well.But any kid who has worked on a bike can do that. (and I've done my share of that in the past.) ;-) Please let me know what you think? C.A.G. -- You received this message because you are subscribed to the Google Groups "Legacy Ornamental Mills" group. To post to this group, send email to legacy-ornamental-mills@googlegroups.com. To unsubscribe from this group, send email to legacy-ornamental-mills+unsubscr...@googlegroups.com. For more options, visit this group at http://groups.google.com/group/legacy-ornamental-mills?hl=en. ------------------------------------------------------------------------------ No virus found in this message. Checked by AVG - www.avg.com Version: 2012.0.1873 / Virus Database: 2102/4665 - Release Date: 12/07/11 -- You received this message because you are subscribed to the Google Groups "Legacy Ornamental Mills" group. To post to this group, send email to legacy-ornamental-mills@googlegroups.com. To unsubscribe from this group, send email to legacy-ornamental-mills+unsubscr...@googlegroups.com. For more options, visit this group at http://groups.google.com/group/legacy-ornamental-mills?hl=en.