Tim I was thinking this stuff would work, http://www.loctiteproducts.com/p/epxy_plstc_s/overview/Loctite-Epoxy-Plastic-Bonder.htm
---- Tim Krause <artmarb...@comcast.net> wrote: > There is no glue that will work with Delrin. I would think there is room to > drill and tap a hole sideways that would pinch the part together. Otherwise > I would make another part. Is the part actually loose right now? You might > try using a larger washer to spread the load a little and see if that makes > the part tight. > > -Tim > > ----- Original Message ----- > From: Brandon Khoury > To: legacy-ornamental-mills@googlegroups.com > Sent: Tuesday, January 08, 2013 4:48 PM > Subject: Ooops... > > > > > So, I noticed some backlash in my Y axis. When I made an adjustment, I > guess I slightly over tightened the set screw. Does anyone have any > experience repairing parts like this? My first thought is to use JB weld, but > mine has been sitting in a room that has been between 42 and 44 degrees for > several weeks. So, I'm not sure if it will even work anymore. > > -- > You received this message because you are subscribed to the Google Groups > "Legacy Ornamental Mills" group. > To post to this group, send email to > legacy-ornamental-mills@googlegroups.com. > To unsubscribe from this group, send email to > legacy-ornamental-mills+unsubscr...@googlegroups.com. > Visit this group at > http://groups.google.com/group/legacy-ornamental-mills?hl=en. > For more options, visit https://groups.google.com/groups/opt_out. > > > > -- > You received this message because you are subscribed to the Google Groups > "Legacy Ornamental Mills" group. > To post to this group, send email to legacy-ornamental-mills@googlegroups.com. > To unsubscribe from this group, send email to > legacy-ornamental-mills+unsubscr...@googlegroups.com. > Visit this group at > http://groups.google.com/group/legacy-ornamental-mills?hl=en. > For more options, visit https://groups.google.com/groups/opt_out. > > -- You received this message because you are subscribed to the Google Groups "Legacy Ornamental Mills" group. To post to this group, send email to legacy-ornamental-mills@googlegroups.com. To unsubscribe from this group, send email to legacy-ornamental-mills+unsubscr...@googlegroups.com. Visit this group at http://groups.google.com/group/legacy-ornamental-mills?hl=en. For more options, visit https://groups.google.com/groups/opt_out.