----- Original Message ----- From: "Brandon Khoury" <blkhou...@gmail.com> To: <legacy-ornamental-mills@googlegroups.com> Sent: Monday, January 21, 2013 6:13 PM Subject: Re: Tail stock connection
Hey Curtis, yes the plate was installed incorrectly and the Zirt was between the plate and the screws instead of on the opposite side of the plate. I haven't taken it apart yet, but I can see the Zirt on the screw. I can't get the screw loose, so Ill have to take the back end apart to slide out the entire tail stock. I was thinking about replacing the existing plate with a 1/4" aluminum plate I have at work. Drill and tap it to fit the existing screw. But, without seeing the part and how it fits, I'm not sure if it will work or not. Brandon -- You received this message because you are subscribed to the Google Groups "Legacy Ornamental Mills" group. To post to this group, send email to legacy-ornamental-mills@googlegroups.com. To unsubscribe from this group, send email to legacy-ornamental-mills+unsubscr...@googlegroups.com. Visit this group at http://groups.google.com/group/legacy-ornamental-mills?hl=en. For more options, visit https://groups.google.com/groups/opt_out. -- You received this message because you are subscribed to the Google Groups "Legacy Ornamental Mills" group. To post to this group, send email to legacy-ornamental-mills@googlegroups.com. To unsubscribe from this group, send email to legacy-ornamental-mills+unsubscr...@googlegroups.com. Visit this group at http://groups.google.com/group/legacy-ornamental-mills?hl=en. For more options, visit https://groups.google.com/groups/opt_out.
