Brandon that is one nice set up! It looks like it should work nicely. what kind of materiel are you going to make it out of ? I know that you were talking wood, but a cast alum. or thermal plastic would be very nice as well. I cant wait to see the final set up on your machine. Awesome idea/ sketch. C.A.G.
----- Original Message ----- I had a few minutes after work to put a couple of the lift design ideas into sketchup. Its not to scale, but I think it gives a good representation of how the sliding plates would work to provide stability and be able to be locked in place. Opinions? Ready....GO! Brandon -- You received this message because you are subscribed to the Google Groups "Legacy Ornamental Mills" group. To unsubscribe from this group and stop receiving emails from it, send an email to legacy-ornamental-mills+unsubscr...@googlegroups.com. To post to this group, send email to legacy-ornamental-mills@googlegroups.com. Visit this group at http://groups.google.com/group/legacy-ornamental-mills. For more options, visit https://groups.google.com/d/optout. -- You received this message because you are subscribed to the Google Groups "Legacy Ornamental Mills" group. To unsubscribe from this group and stop receiving emails from it, send an email to legacy-ornamental-mills+unsubscr...@googlegroups.com. To post to this group, send email to legacy-ornamental-mills@googlegroups.com. Visit this group at http://groups.google.com/group/legacy-ornamental-mills. For more options, visit https://groups.google.com/d/optout.